Worked example
Example: Hook-like: ri 50, h 40, b 20 mm, closing 1.5 kN·m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Inner radius | 50.000 mm |
| Section depth (radial) | 40.000 mm |
| Section width | 20.000 mm |
| Bending moment (positive straightens the beam) | -1,500.0 N·m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Radius of the centroid | 70.000 mm |
| Radius of the neutral axis h/ln(r_o/r_i) | 68.052 mm |
| Neutral axis shift r_c − r_n | 1.9481 mm |
| Stress at the inner fibre | -347.49 MPa |
| Stress at the outer fibre | 234.72 MPa |
| Straight-beam stress 6M/(b h²) for comparison | 281.25 MPa |
Open this example in the calculator and change any input.
Formula
\(r_n = \frac{h}{\ln(r_o/r_i)}, \quad e = r_c - r_n, \quad \sigma_i = \frac{M(r_n - r_i)}{A e r_i}, \quad \sigma_o = \frac{M(r_n - r_o)}{A e r_o}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(r_i\) | Inner radius | m |
| \(h\) | Section depth (radial) | m |
| \(b\) | Section width | m |
| \(M\) | Bending moment (positive straightens the beam) | N·m |
| \(r_c\) | Radius of the centroid | m |
| \(r_n\) | Radius of the neutral axis h/ln(r_o/r_i) | m |
| \(e\) | Neutral axis shift r_c − r_n | m |
| \(\sigma_i\) | Stress at the inner fibre | Pa |
| \(\sigma_o\) | Stress at the outer fibre | Pa |
| \(\sigma_{straight}\) | Straight-beam stress 6M/(b h²) for comparison | Pa |
Method and standards
Winkler–Bach curved beam theory.
Where it is used
- Hooks, clamps, C-frames and press frames.
- Strength of materials examinations.
Common mistakes
- Using the straight-beam formula.
- Rounding e (a small difference of large numbers).
Assumptions and limits
- Rectangular section, elastic.
- For large radius-to-depth ratios the shift e is found from the series of ln(r_o/r_i), avoiding the loss of digits in r_c − r_n.
- Bending only: in a crane hook add the direct stress P/A to both fibres.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 3 (curved beams in bending, rectangular section r_n = h / ln(r_o/r_i))
Questions and answers
Why is the inner fibre stress higher?
The neutral axis shifts towards the centre of curvature, and the inner fibres are shorter.
How much higher?
For r_i = 50 mm and h = 40 mm, about 24 % above the straight-beam value.
When can curvature be ignored?
When the radius is large compared with the depth (r_c/h above about 10).
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.