Worked example
Example: Brass bar in steel tube, 80 K. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Temperature rise | 80.000 K |
| Expansion coefficient of material 1 | 17.000 µm/(m·K) |
| Modulus of material 1 | 110.00 GPa |
| Area of material 1 | 600.00 mm² |
| Expansion coefficient of material 2 | 12.000 µm/(m·K) |
| Modulus of material 2 | 200.00 GPa |
| Area of material 2 | 400.00 mm² |
Applying the formula below gives:
| Result | Value |
|---|---|
| Stress in material 1 (negative = compression) | -24.110 MPa |
| Stress in material 2 | 36.164 MPa |
| Force carried (equal and opposite) | 14.466 kN |
| Common strain | 0.001141 |
Open this example in the calculator and change any input.
Formula
\(\sigma_1 = \frac{(\alpha_2 - \alpha_1)\Delta T}{\dfrac{1}{E_1} + \dfrac{A_1}{A_2 E_2}}, \quad \sigma_2 = -\sigma_1 \frac{A_1}{A_2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\Delta T\) | Temperature rise | K |
| \(\alpha_1\) | Expansion coefficient of material 1 | 1/K |
| \(E_1\) | Modulus of material 1 | Pa |
| \(A_1\) | Area of material 1 | m² |
| \(\alpha_2\) | Expansion coefficient of material 2 | 1/K |
| \(E_2\) | Modulus of material 2 | Pa |
| \(A_2\) | Area of material 2 | m² |
| \(\sigma_1\) | Stress in material 1 (negative = compression) | Pa |
| \(\sigma_2\) | Stress in material 2 | Pa |
| \(F\) | Force carried (equal and opposite) | N |
| \(\varepsilon\) | Common strain | - |
Method and standards
Equal strains and equal and opposite forces.
Where it is used
- Bolted joints with gaskets, lined pipes.
- Strength of materials examinations.
Common mistakes
- Sign of the coefficient difference.
- Forgetting the force balance.
Assumptions and limits
- Elastic, joined at the ends.
References
- Textbook mechanics (compatibility and equilibrium of a compound bar, Timoshenko, Strength of Materials)
Questions and answers
A brass bar in a steel tube heated 80 K?
The brass (expands more) goes into compression and the steel into tension, with equal and opposite forces.
Why do areas matter?
The force is shared; the smaller area sees the larger stress.
Where does it occur?
Bolts through gaskets, bimetal joints and lined pipes.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.