FireCADCalc

Thermal Stress in a Composite Bar (Two Materials)

Stresses in two bars of different materials joined to share the same length (bar in a tube, bolt in a sleeve) when heated, from expansion coefficients and areas.

Inputs

Examples: Brass bar in steel tube, 80 KAluminium in steel, 50 KSteel bolt in copper sleeve, cooled 40 K

Results

Stress in material 1 (negative = compression)-31.216MPa
Stress in material 220.811MPa
Force carried (equal and opposite)31.216kN
Common strain7.0405e-04

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Brass bar in steel tube, 80 K. The inputs, in the units selected above:

InputValue
Temperature rise80.000 K
Expansion coefficient of material 117.000 µm/(m·K)
Modulus of material 1110.00 GPa
Area of material 1600.00 mm²
Expansion coefficient of material 212.000 µm/(m·K)
Modulus of material 2200.00 GPa
Area of material 2400.00 mm²

Applying the formula below gives:

ResultValue
Stress in material 1 (negative = compression)-24.110 MPa
Stress in material 236.164 MPa
Force carried (equal and opposite)14.466 kN
Common strain0.001141

Open this example in the calculator and change any input.

Formula

\(\sigma_1 = \frac{(\alpha_2 - \alpha_1)\Delta T}{\dfrac{1}{E_1} + \dfrac{A_1}{A_2 E_2}}, \quad \sigma_2 = -\sigma_1 \frac{A_1}{A_2}\)

Variables

Symbol Meaning SI unit
\(\Delta T\) Temperature rise K
\(\alpha_1\) Expansion coefficient of material 1 1/K
\(E_1\) Modulus of material 1 Pa
\(A_1\) Area of material 1 m²
\(\alpha_2\) Expansion coefficient of material 2 1/K
\(E_2\) Modulus of material 2 Pa
\(A_2\) Area of material 2 m²
\(\sigma_1\) Stress in material 1 (negative = compression) Pa
\(\sigma_2\) Stress in material 2 Pa
\(F\) Force carried (equal and opposite) N
\(\varepsilon\) Common strain -

Method and standards

Equal strains and equal and opposite forces.

Where it is used

  • Bolted joints with gaskets, lined pipes.
  • Strength of materials examinations.

Common mistakes

  • Sign of the coefficient difference.
  • Forgetting the force balance.

Assumptions and limits

  • Elastic, joined at the ends.

References

  • Textbook mechanics (compatibility and equilibrium of a compound bar, Timoshenko, Strength of Materials)

Questions and answers

A brass bar in a steel tube heated 80 K?

The brass (expands more) goes into compression and the steel into tension, with equal and opposite forces.

Why do areas matter?

The force is shared; the smaller area sees the larger stress.

Where does it occur?

Bolts through gaskets, bimetal joints and lined pipes.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.