Worked example
Example: 2 m bracket, 2 kN/m + 5 kN, I 1 943 cm⁴, Z 194 cm³. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Length from the fixed end | 2.0000 m |
| Uniformly distributed load (including self weight) | 2.0000 kN/m |
| Point load at the free end | 5.0000 kN |
| Modulus of elasticity | 200.00 GPa |
| Second moment of area | 1,943.0 cm⁴ |
| Elastic section modulus | 194.00 cm³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Bending moment at the fixed end | 14.000 kN·m |
| Tip deflection | 4.4605 mm |
| Maximum bending stress | 72.165 MPa |
| Reaction at the fixed end | 9.0000 kN |
| Length over deflection | 448.38 |
Open this example in the calculator and change any input.
Formula
\(R = wL + P \qquad M_{max} = \frac{wL^2}{2} + PL \qquad \delta_{max} = \frac{wL^4}{8EI} + \frac{PL^3}{3EI} \qquad \sigma_b = \frac{M_{max}}{Z}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(L\) | length | m |
| \(w\) | distributed load | N/m |
| \(P\) | tip load | N |
| \(E\) | modulus of elasticity | Pa |
| \(I\) | second moment of area | m⁴ |
| \(Z\) | section modulus | m³ |
| \(M_{max}\) | fixed-end moment | N·m |
| \(\delta_{max}\) | tip deflection | m |
| \(\sigma_b\) | bending stress | Pa |
| \(R\) | fixed-end reaction | N |
| \(L/\delta\) | length over deflection | – |
Method and standards
Euler–Bernoulli small-deflection theory for a cantilever, superposing the two load cases.
Where it is used
- Pipe support brackets.
- Platform and walkway brackets.
- Davit and lifting arms (with factors).
Common mistakes
- Assuming a bolted end plate is fully fixed.
- Leaving out self weight.
- Mixing units of I and Z.
Assumptions and limits
- Linear elastic; fully fixed support.
- The stress is not compared with an allowable. I and Z are entered separately: take both from the same section, as an inconsistent pair is not detected.
References
- Euler–Bernoulli beam theory
Questions and answers
What does a 2 m bracket with 2 kN/m and 5 kN at the tip do?
14 kN·m at the wall, 4.46 mm tip deflection and 72 MPa with I 1943 cm⁴, Z 194 cm³.
Why is the tip deflection so sensitive to length?
It grows with the cube (point load) or fourth power (uniform load) of length.
Is the support really fixed?
Rarely fully; a support that rotates adds deflection.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.