FireCADCalc

Duct Velocity and Velocity Pressure

Air velocity and velocity pressure in a round or rectangular duct from flow and size, with the air density from temperature and pressure.

Inputs

Examples: Rectangular 600 × 400 at 20 °CRound 500 mm flue gas duct at 150 °C

Results

Air density (dry air)1.2042kg/m³
Velocity9.2593m/s
Velocity pressure ρv²/25.2636mmWC

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Rectangular 600 × 400 at 20 °C. The inputs, in the units selected above:

InputValue
Air flow8,000.0 m³/h
Duct shapeRectangular
Diameter (round)500.00 mm
Width (rectangular)600.00 mm
Height (rectangular)400.00 mm
Air temperature20.000 °C
Barometric pressure (absolute)101.33 kPa

Applying the formula below gives:

ResultValue
Air density (dry air)1.2042 kg/m³
Velocity9.2593 m/s
Velocity pressure ρv²/25.2636 mmWC

Open this example in the calculator and change any input.

Formula

\(v = \frac{\dot V}{A}, \quad p_v = \frac{\rho v^2}{2}, \quad \rho = \frac{p M}{R T}\)

Variables

Symbol Meaning SI unit
\(\dot V\) Air flow m³/s
\(\text{shape}\) Duct shape -
\(D\) Diameter (round) m
\(W\) Width (rectangular) m
\(H\) Height (rectangular) m
\(T\) Air temperature K
\(p\) Barometric pressure (absolute) Pa
\(\rho\) Air density (dry air) kg/m³
\(v\) Velocity m/s
\(p_v\) Velocity pressure ρv²/2 Pa

Method and standards

Bernoulli.

Where it is used

  • Duct design and fitting losses.
  • Pitot traverses.

Common mistakes

  • Standard density at high temperature.
  • Gross instead of inside dimensions.

Assumptions and limits

  • Uniform velocity.
  • Dry air of standard composition: humidity and flue-gas composition change the density (flue gas is often 3–5 % denser than air at the same temperature), so for flue gas use a calculator that takes its density.

References

  • Velocity pressure p_v = ρv²/2 (ASHRAE Handbook—Fundamentals (2017), ch. 21); dry-air density from the ideal gas law

Questions and answers

8000 m³/h in a 600 × 400 duct at 20 °C?

About 9.3 m/s and 52 Pa of velocity pressure.

Why does density matter?

Hot flue gas ducts have far lower velocity pressure for the same speed.

Pitot readings?

Invert: v = √(2p_v/ρ).

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.