Worked example
Example: Air 20 m³/s at 15 m/s, aspect 1.6. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Volume flow (actual) | 72,000 m³/h |
| Design velocity | 15.000 m/s |
| Aspect ratio of the rectangular duct (width / height) | 1.6000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Round duct inside diameter | 1,302.9 mm |
| Rectangular duct width | 1,460.6 mm |
| Rectangular duct height | 912.87 mm |
| Flow area | 1.3333 m² |
| Equivalent diameter of the rectangle (Huebscher) | 1,253.7 mm |
Open this example in the calculator and change any input.
Formula
\(A = \frac{\dot V}{v} \qquad D = \sqrt{\frac{4A}{\pi}} \qquad a = \sqrt{A \cdot AR} \qquad b = \frac{a}{AR} \qquad D_e = \frac{1.30\,(ab)^{0.625}}{(a+b)^{0.25}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V\) | actual volume flow | m³/s |
| \(v\) | design velocity | m/s |
| \(AR\) | aspect ratio width / height | – |
| \(D\) | round duct inside diameter | m |
| \(a\) | rectangular duct width | m |
| \(b\) | rectangular duct height | m |
| \(A\) | flow area | m² |
| \(D_e\) | equivalent diameter of the rectangle | m |
Method and standards
Continuity for the flow area; Huebscher's equivalent diameter (ASHRAE Handbook—Fundamentals, Duct Design).
Where it is used
- First sizing of air and flue gas ducts.
- Checking duct velocities for erosion and noise.
- Layout studies.
Common mistakes
- Using normal volume flow instead of actual.
- Choosing high velocities in dusty gas, which erodes ducts.
- Ignoring pressure drop on long runs.
Assumptions and limits
- Inside dimensions; add insulation, lining or refractory thickness for the outside size.
- Round the result to the standard sizes you use and recheck the velocity.
- The rectangle has the same area (same velocity) as the round duct, so its friction-equivalent diameter D_e is smaller than D and it has more friction per metre. For a rectangle equal in friction, use the equal-friction sizing calculator.
References
- Continuity equation; Huebscher (1948) equivalent diameter
Questions and answers
How do I size a duct?
Area = flow ÷ velocity. 20 m³/s at 15 m/s needs 1.33 m²: a 1 303 mm round duct, or 1 461 × 913 mm rectangular at an aspect ratio of 1.6.
Which velocity should I use?
The one in your specification or duct design standard; it balances duct cost against pressure drop, noise and erosion. The calculator does not suggest one.
Why is the equivalent diameter smaller than the round duct?
A rectangle has more wall per unit area than a circle, so for the same friction it behaves like a smaller round duct; check the pressure drop with the duct pressure drop calculator.
Method and article reviewed by FireCAD engineering on 10 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.