Worked example
Example: 4-pole 50 Hz motor at 1 475 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Supply frequency | 50.000 Hz |
| Number of poles | 4 |
| Running (rotor) speed | 1,475.0 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Synchronous speed | 1,500.0 rpm |
| Slip | 1.6667 % |
| Slip speed | 25.000 rpm |
| Rotor current frequency | 0.83333 Hz |
Open this example in the calculator and change any input.
Formula
\(n_s = \frac{120 f}{p} \ \text{rpm} \;\; (= 2f/p \ \text{rev/s})\)
\(s = \frac{n_s - n}{n_s}, \quad f_r = s f\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(f\) | supply frequency | Hz |
| \(p\) | number of poles | - |
| \(n\) | running speed | rev/s |
| \(n_s\) | synchronous speed | rev/s |
| \(s\) | slip | - |
| \(n_s - n\) | slip speed | rev/s |
| \(f_r\) | rotor current frequency | Hz |
Method and standards
The stator field turns once every p/2 cycles of the supply, so its speed is 2f/p revolutions per second (120 f/p in rpm). Slip is the rotor's lag behind the field as a share of synchronous speed; rotor currents alternate at slip times supply frequency.
Where it is used
- Checking the load on a motor from its measured speed.
- Choosing poles for a fan or pump speed.
- Setting a VFD frequency for a target speed.
Common mistakes
- Using 60 Hz speeds on a 50 Hz supply.
- Counting pole pairs as poles (a 4-pole motor has 2 pole pairs).
- Expecting a motor on a VFD to run exactly at f×120/p: it still slips.
Assumptions and limits
- Induction motors; synchronous motors run at n_s with zero slip.
- Steady running speed.
References
- n_s = 120 f / p
Questions and answers
What is the speed of a 4-pole motor on 50 Hz?
The field turns at 1 500 rpm. A motor running at 1 475 rpm has 1.67 % slip, and its rotor currents are at 0.83 Hz.
Why does an induction motor never reach synchronous speed?
Torque needs rotor current, and rotor current needs the rotor to slip behind the field; slip grows roughly in proportion to load.
What does negative slip mean?
The rotor is driven faster than the field, so the machine feeds power back: it is running as an induction generator.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.