FireCADCalc

Resistor Colour Code Calculator (4 Band)

Resistance and tolerance of a four-band resistor from its colour bands, with the lowest and highest values the tolerance allows (IEC 60062 code).

Inputs

Examples: Yellow, violet, red, gold: 4.7 kΩ ±5 %Brown, black, orange, brown: 10 kΩ ±1 %Red, red, gold, gold: 2.2 Ω ±5 %

Results

Resistance2.2000Ω
Lowest value within tolerance2.0900Ω
Highest value within tolerance2.3100Ω

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Yellow, violet, red, gold: 4.7 kΩ ±5 %. The inputs, in the units selected above:

InputValue
First band (first digit)Yellow (4)
Second band (second digit)Violet (7)
Third band (multiplier)Red (×10^2)
Fourth band (tolerance)Gold (±5 %)

Applying the formula below gives:

ResultValue
Resistance4,700.0 Ω
Lowest value within tolerance4,465.0 Ω
Highest value within tolerance4,935.0 Ω

Open this example in the calculator and change any input.

Formula

\(R = (10 d_1 + d_2) \times 10^{m} \pm t\)

Variables

Symbol Meaning SI unit
\(d_1\) First band (first digit) -
\(d_2\) Second band (second digit) -
\(m\) Third band (multiplier) -
\(t\) Fourth band (tolerance) -
\(R\) Resistance Ω
\(R_{min}\) Lowest value within tolerance Ω
\(R_{max}\) Highest value within tolerance Ω

Method and standards

Digits, multiplier and tolerance by colour.

Where it is used

  • Electronics repair and panel work.
  • Training.

Common mistakes

  • Reading from the tolerance end.
  • Confusing red and orange in poor light.

Assumptions and limits

  • Four-band resistors, with the common tolerance colours listed. Grey and the tighter tolerance colours are left out because editions of IEC 60062 assign them differently; read them from the maker's data.

References

  • IEC 60062 (marking codes for resistors and capacitors)

Questions and answers

What is yellow, violet, red, gold?

47 × 100 = 4700 Ω (4.7 kΩ) ±5 %: 4465 to 4935 Ω.

Which end do I read from?

The tolerance band (gold or silver) is set apart at the right.

What about five bands?

They have three digits before the multiplier; not covered here.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.