Worked example
Example: Yellow, violet, red, gold: 4.7 kΩ ±5 %. The inputs, in the units selected above:
| Input | Value |
|---|---|
| First band (first digit) | Yellow (4) |
| Second band (second digit) | Violet (7) |
| Third band (multiplier) | Red (×10^2) |
| Fourth band (tolerance) | Gold (±5 %) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Resistance | 4,700.0 Ω |
| Lowest value within tolerance | 4,465.0 Ω |
| Highest value within tolerance | 4,935.0 Ω |
Open this example in the calculator and change any input.
Formula
\(R = (10 d_1 + d_2) \times 10^{m} \pm t\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d_1\) | First band (first digit) | - |
| \(d_2\) | Second band (second digit) | - |
| \(m\) | Third band (multiplier) | - |
| \(t\) | Fourth band (tolerance) | - |
| \(R\) | Resistance | Ω |
| \(R_{min}\) | Lowest value within tolerance | Ω |
| \(R_{max}\) | Highest value within tolerance | Ω |
Method and standards
Digits, multiplier and tolerance by colour.
Where it is used
- Electronics repair and panel work.
- Training.
Common mistakes
- Reading from the tolerance end.
- Confusing red and orange in poor light.
Assumptions and limits
- Four-band resistors, with the common tolerance colours listed. Grey and the tighter tolerance colours are left out because editions of IEC 60062 assign them differently; read them from the maker's data.
References
- IEC 60062 (marking codes for resistors and capacitors)
Questions and answers
What is yellow, violet, red, gold?
47 × 100 = 4700 Ω (4.7 kΩ) ±5 %: 4465 to 4935 Ω.
Which end do I read from?
The tolerance band (gold or silver) is set apart at the right.
What about five bands?
They have three digits before the multiplier; not covered here.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.