Worked example
Example: 50 Hz, 100 Ω, 0.2 H, 40 µF, 230 V. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Supply frequency | 50.000 Hz |
| Resistance | 100.00 Ω |
| Inductance | 200.00 mH |
| Capacitance | 40.000 µF |
| Supply voltage (rms) | 230.00 V |
Applying the formula below gives:
| Result | Value |
|---|---|
| Current in the resistor | 2.3000 A |
| Current in the inductor | 3.6606 A |
| Current in the capacitor | 2.8903 A |
| Total current | 2.4256 A |
| Impedance | 94.823 Ω |
| Power factor | 0.94823 |
| Resonant frequency | 56.270 Hz |
| Quality factor R √(C/L) | 1.4142 |
Open this example in the calculator and change any input.
Formula
\(Y = \sqrt{\frac{1}{R^2} + \left(\omega C - \frac{1}{\omega L}\right)^2}, \quad I = V\, Y, \quad f_0 = \frac{1}{2\pi\sqrt{LC}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(f\) | Supply frequency | 1/s |
| \(R\) | Resistance | Ω |
| \(L\) | Inductance | H |
| \(C\) | Capacitance | F |
| \(V\) | Supply voltage (rms) | V |
| \(I_R\) | Current in the resistor | A |
| \(I_L\) | Current in the inductor | A |
| \(I_C\) | Current in the capacitor | A |
| \(I\) | Total current | A |
| \(Z\) | Impedance | Ω |
| \(\cos\varphi\) | Power factor | - |
| \(f_0\) | Resonant frequency | 1/s |
| \(Q\) | Quality factor R √(C/L) | - |
Method and standards
Admittances add in parallel.
Where it is used
- Capacitor banks with inductive loads.
- Filters.
Common mistakes
- Adding branch currents arithmetically.
- Series and parallel Q mixed up.
Assumptions and limits
- Ideal components.
- The power factor is given as a magnitude; a note says whether it is leading (capacitive, ωC > 1/ωL) or lagging (inductive).
References
- AC circuit theory (admittances in parallel)
Questions and answers
What happens at resonance in a parallel circuit?
The inductor and capacitor currents cancel, so the supply sees only R: impedance is highest.
Is that power factor correction?
Yes: a capacitor in parallel with an inductive load cancels part of its lagging current.
What is Q here?
R √(C/L): the ratio of circulating to supply current at resonance.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.