FireCADCalc

Energy Stored in a Capacitor and an Inductor

Energy stored in a capacitor from capacitance and voltage with its charge, and in an inductor from inductance and current with its flux linkage.

Inputs

Examples: 470 µF at 400 V; 50 mH at 10 A10 µF at 24 V; 2 H relay coil at 0.1 A3 300 µF at 680 V DC bus; 1 mH at 200 A

Results

Energy in the capacitor ½ C V²37.600J
Charge C V0.18800C
Energy in the inductor ½ L I²2.5000J
Flux linkage L I0.50000Wb

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 470 µF at 400 V; 50 mH at 10 A. The inputs, in the units selected above:

InputValue
Capacitance470.00 µF
Voltage on the capacitor (DC or instantaneous; peak for an AC capacitor)400.00 V
Inductance50.000 mH
Current in the inductor10.000 A

Applying the formula below gives:

ResultValue
Energy in the capacitor ½ C V²37.600 J
Charge C V0.18800 C
Energy in the inductor ½ L I²2.5000 J
Flux linkage L I0.50000 Wb

Open this example in the calculator and change any input.

Formula

\(E_C = \tfrac12 C V^2, \quad Q = C V, \quad E_L = \tfrac12 L I^2, \quad \Psi = L I\)

Variables

Symbol Meaning SI unit
\(C\) Capacitance F
\(V\) Voltage on the capacitor (DC or instantaneous; peak for an AC capacitor) V
\(L\) Inductance H
\(I\) Current in the inductor A
\(E_C\) Energy in the capacitor ½ C V² J
\(Q\) Charge C V C
\(E_L\) Energy in the inductor ½ L I² J
\(\Psi\) Flux linkage L I Wb

Method and standards

Stored field energy.

Where it is used

  • Drive DC links and discharge resistors.
  • Relay coil suppression.

Common mistakes

  • µF entered as F.
  • Using RMS for a DC bus.

Assumptions and limits

  • Linear components.
  • V and I are instantaneous (or DC) values. For an AC capacitor the peak stored energy uses the peak voltage √2 × V_rms; entering the RMS value gives half the peak energy (the same holds for the inductor current).

References

  • E = ½ C V²
  • E = ½ L I² (circuit theory)

Questions and answers

How much energy is in 470 µF at 400 V?

37.6 J, enough to be dangerous.

And in 50 mH carrying 10 A?

2.5 J.

Why discharge capacitors before work?

They hold their charge after switch-off; DC bus capacitors of drives can be lethal.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.