FireCADCalc

Knitted Fabric GSM from Stitch Density and Loop Length

Grams per square metre of a weft-knitted fabric from courses and wales per cm, loop (stitch) length and yarn tex, with the tightness factor.

Food, dairy and textile

Inputs

Examples: Single jersey 18 × 14, 2.8 mm, 20 texRib 16 × 12, 3.2 mm, 30 tex

Results

Stitch density per cm²252.00
Fabric mass per m²141.12g/m²
Tightness factor √tex / ℓ(mm)1.5972

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Single jersey 18 × 14, 2.8 mm, 20 tex. The inputs, in the units selected above:

InputValue
Courses per cm18.000 -
Wales per cm14.000 -
Loop length2.8000 mm
Yarn tex20.000 -

Applying the formula below gives:

ResultValue
Stitch density per cm²252.00
Fabric mass per m²141.12 g/m²
Tightness factor √tex / ℓ(mm)1.5972

Open this example in the calculator and change any input.

Formula

\(G = c\,w \times 10^4 \cdot \ell \cdot T \times 10^{-6}\ \ (\ell\ \text{in m},\ T\ \text{in tex},\ G\ \text{in kg/m}^2), \quad TF = \frac{\sqrt{T}}{\ell\,[\mathrm{mm}]}\)

Variables

Symbol Meaning SI unit
\(c\) Courses per cm -
\(w\) Wales per cm -
\(\ell\) Loop length m
\(T\) Yarn tex -
\(S\) Stitch density per cm² -
\(G\) Fabric mass per m² kg/m²
\(TF\) Tightness factor √tex / ℓ(mm) -

Method and standards

Yarn mass per unit area.

Where it is used

  • Knit fabric design and costing.

Common mistakes

  • Using loop length in cm.
  • Measuring stitch density on grey instead of finished fabric.

Assumptions and limits

  • Single-jersey structure.

References

  • Definitions and mass and energy balances: loops per m² × yarn mass per loop

Questions and answers

Why loops per area?

Each loop uses one loop length of yarn, so mass is loops × length × linear density.

What is tightness factor?

√tex divided by loop length in mm; about 1.4–1.5 for normal single jersey.

Does finishing change GSM?

Yes: relaxation and compaction raise stitch density.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.