Worked example
Example: 30-inch, 28 gauge, 90 feeders, 25 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Machine speed | 25.000 rpm |
| Feeders | 90.000 - |
| Needles (cylinder) | 2,640.0 - |
| Stitch length | 2.8000 mm |
| Yarn linear density (tex) | 20.000 - |
| Efficiency | 85.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Yarn consumed | 14,137 m/min |
| Fabric production | 16.965 kg/h |
Open this example in the calculator and change any input.
Formula
\(\dot L_y = N F n_d \ell\eta, \quad \dot M = \dot L_y T \times 10^{-6}\ \mathrm{kg/m\ per\ tex}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(N\) | Machine speed | 1/s |
| \(F\) | Feeders | - |
| \(n_d\) | Needles (cylinder) | - |
| \(\ell\) | Stitch length | m |
| \(T\) | Yarn linear density (tex = g per 1000 m = 10⁻⁶ kg/m) | - |
| \(\eta\) | Efficiency | - |
| \(\dot L_y\) | Yarn consumed | m/s |
| \(\dot M\) | Fabric production | kg/s |
Method and standards
Yarn length balance.
Where it is used
- Knitting capacity planning.
Common mistakes
- Using loop length in cm.
- Forgetting efficiency.
Assumptions and limits
- Single-jersey type; one loop per needle per feeder.
References
- Definitions and mass and energy balances: yarn knitted = speed × feeders × needles × stitch length
Questions and answers
Why does every needle count on every feeder?
Each feeder lays one course: every needle forms one loop per feeder per revolution.
What output is typical?
A 30-inch single jersey machine makes roughly 15–30 kg/h of 20-tex fabric, depending on speed and stitch length.
What lowers efficiency?
Yarn breaks, doffing and changes; 80–90 % is common.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.