Worked example
Example: A ⇌ B, ΔG° +5 kJ/mol, 600 K. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Standard Gibbs energy of reaction at T | 5.0000 kJ/mol |
| Temperature | 326.85 °C |
| Reaction | A ⇌ B (no mole change) |
| Pressure (for A ⇌ 2B) | 1.0132 bar |
| Inert moles per mole of A fed | 0 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Equilibrium constant | 0.36705 |
| Equilibrium conversion of A | 26.850 % |
Open this example in the calculator and change any input.
Formula
\(K = \exp\left(-\frac{\Delta G^\circ}{RT}\right), \quad X_e = \frac{K}{1 + K}\ (A\rightleftharpoons B), \quad K = \frac{(2X/n_T)^2}{(1 - X)/n_T}\frac{p}{p^\circ}\ (A\rightleftharpoons2B)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\Delta G^\circ\) | Standard Gibbs energy of reaction at T | J/mol |
| \(T\) | Temperature | K |
| \(\text{type}\) | Reaction | - |
| \(p\) | Pressure (for A ⇌ 2B) | Pa |
| \(n_I\) | Inert moles per mole of A fed | - |
| \(K\) | Equilibrium constant | - |
| \(X_e\) | Equilibrium conversion of A | - |
Method and standards
Chemical equilibrium.
Where it is used
- Feasibility screening of reactions.
- Choosing temperature and pressure.
Common mistakes
- Using ΔG° at 298 K for a hot reactor.
- Forgetting the standard-state pressure.
Assumptions and limits
- Ideal gas or ideal solution.
- Only two stoichiometries are covered, A ⇌ B and A ⇌ 2B; ΔG° must be the value at the reaction temperature T (use the van 't Hoff calculator to move it from 298 K). R from CODATA.
References
- K = exp(−ΔG°/RT) (Smith, Van Ness and Abbott, Introduction to Chemical Engineering Thermodynamics, ch. 13)
Questions and answers
Why does ΔG° = 0 give 50 % for A ⇌ B?
K = 1, so at equilibrium A and B are equal.
Why does pressure matter for A ⇌ 2B?
The reaction makes more moles; higher pressure pushes it back (Le Chatelier). Inerts lower the partial pressures and help.
What do the defaults represent?
A reaction with ΔG° = +5 kJ/mol at 600 K: K about 0.37.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.