FireCADCalc

Equilibrium Constant from ΔG° and van 't Hoff Temperature Correction

Equilibrium constant from the standard Gibbs energy of reaction, and its value at another temperature by the van 't Hoff equation with a constant heat of reaction.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: Ammonia synthesis to 700 KEndothermic reaction to 500 K

Results

Constant ΔH° over the range; for wide ranges integrate with heat capacities.

Equilibrium constant at T₁3.1344e-04
Equilibrium constant at T₂5.4911
ln K₂1.7031

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Ammonia synthesis to 700 K. The inputs, in the units selected above:

InputValue
Standard Gibbs energy of reaction at T₁-32.900 kJ/mol
Temperature of ΔG°25.000 °C
Standard heat of reaction-92.200 kJ/mol
Temperature of interest426.85 °C

Applying the formula below gives:

ResultValue
Equilibrium constant at T₁580,538
Equilibrium constant at T₂3.0974e-04
ln K₂-8.0798

Open this example in the calculator and change any input.

Formula

\(K_1 = e^{-\Delta G^\circ/RT_1}, \quad \ln\frac{K_2}{K_1} = -\frac{\Delta H^\circ}{R}\left(\frac{1}{T_2} - \frac{1}{T_1}\right)\)

Variables

Symbol Meaning SI unit
\(\Delta G^\circ\) Standard Gibbs energy of reaction at T₁ J/mol
\(T_1\) Temperature of ΔG° K
\(\Delta H^\circ\) Standard heat of reaction J/mol
\(T_2\) Temperature of interest K
\(K_1\) Equilibrium constant at T₁ -
\(K_2\) Equilibrium constant at T₂ -
\(\ln K_2\) ln K₂ -

Method and standards

Thermodynamics.

Where it is used

  • Reactor equilibrium checks.
  • Examinations.

Common mistakes

  • kJ vs J.
  • ΔG at the wrong temperature.

Assumptions and limits

  • Constant ΔH°.

References

  • K = exp(−ΔG°/RT); van 't Hoff ln(K₂/K₁) = −(ΔH°/R)(1/T₂ − 1/T₁)

Questions and answers

Ammonia synthesis (N₂ + 3H₂ ⇌ 2NH₃), K at 700 K?

Falls from about 5.8 × 10⁵ at 25 °C to about 3 × 10⁻⁴: high temperature hurts equilibrium.

Why use high temperature then?

For rate; pressure and recycle make up for the equilibrium.

Exothermic or endothermic?

Exothermic K falls with temperature, endothermic K rises.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.