FireCADCalc

Agitator Scale-Up: Constant Power per Volume or Tip Speed

Speed and power of a geometrically similar larger agitator by constant power per unit volume or constant tip speed, for turbulent mixing.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: P/V constantTip speed constant

Results

Geometric similarity and turbulent flow (constant power number) assumed.

Large impeller speed50.000rpm
Large agitator power1.8000kW
Power per volume ratio0.16667

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: P/V constant. The inputs, in the units selected above:

InputValue
Small impeller diameter0.15000 m
Small impeller speed300.00 rpm
Small agitator power0.050000 kW
Large impeller diameter0.90000 m
Scale-up ruleConstant power per volume (N ∝ D^−2/3)

Applying the formula below gives:

ResultValue
Large impeller speed90.856 rpm
Large agitator power10.800 kW
Power per volume ratio1.00000

Open this example in the calculator and change any input.

Formula

\(N_2 = N_1\left(\frac{D_1}{D_2}\right)^{2/3} \ \text{or} \ N_1\frac{D_1}{D_2}, \quad P_2 = P_1\left(\frac{N_2}{N_1}\right)^3\left(\frac{D_2}{D_1}\right)^5\)

Variables

Symbol Meaning SI unit
\(D_1\) Small impeller diameter m
\(N_1\) Small impeller speed 1/s
\(P_1\) Small agitator power W
\(D_2\) Large impeller diameter m
\(\text{rule}\) Scale-up rule -
\(N_2\) Large impeller speed 1/s
\(P_2\) Large agitator power W
\(\frac{P_2/V_2}{P_1/V_1}\) Power per volume ratio -

Method and standards

Geometric similarity with a constant power number in turbulent flow, so P ∝ N³D⁵ and V ∝ D³; the speed follows from the chosen rule (constant P/V gives N ∝ D−2/3, constant tip speed N ∝ D−1).

Where it is used

  • Pilot to plant agitators.
  • Tank replacement.

Common mistakes

  • Non-similar geometry.
  • Laminar mixing.

Assumptions and limits

  • Turbulent, geometrically similar.

References

  • Turbulent agitation P = N_p ρN³D⁵ with geometric similarity (McCabe, Smith and Harriott)

Questions and answers

150 mm at 300 rpm, 50 W, to 900 mm by P/V?

91 rpm and 10.8 kW.

By tip speed?

50 rpm and 1.8 kW: less power per volume.

Which rule?

P/V for mass transfer and suspension; tip speed for shear-sensitive products.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.