FireCADCalc

Liquid Diffusivity by Wilke–Chang

Diffusion coefficient of a dilute solute in a liquid from temperature, solvent viscosity and molar mass and the solute's molar volume (Wilke–Chang).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Ethanol in water, 25 °CBenzene in ethanol, 25 °C

Results

Average error about 10 %; poor for water as the solute (Perry's).

Diffusion coefficient at infinite dilution1.1042e-05cm²/s

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Ethanol in water, 25 °C. The inputs, in the units selected above:

InputValue
Temperature25.000 °C
Solvent viscosity0.89000 cP
Solvent molar mass18.015 kg/kmol
Solute molar volume at its normal boiling point59.200 cm³/mol
Association factor of the solventWater (2.26)

Applying the formula below gives:

ResultValue
Diffusion coefficient at infinite dilution1.3670e-05 cm²/s

Open this example in the calculator and change any input.

Formula

\(D_{AB}^\circ = \frac{7.4\times10^{-8}(\phi_BM_B)^{1/2}T}{\mu_BV_A^{0.6}}\ \ (\mathrm{cm^2/s};\ \mu\ \mathrm{cP},\ V_A\ \mathrm{cm^3/mol})\)

Variables

Symbol Meaning SI unit
\(T\) Temperature K
\(\mu_B\) Solvent viscosity Pa·s
\(M_B\) Solvent molar mass kg/kmol
\(V_A\) Solute molar volume at its normal boiling point m³/mol
\(\phi_B\) Association factor of the solvent -
\(D_{AB}^\circ\) Diffusion coefficient at infinite dilution m²/s

Method and standards

Wilke–Chang correlation.

Where it is used

  • Liquid mass transfer and reaction rate estimates.

Common mistakes

  • Using for concentrated solutions.
  • Viscosity in Pa·s instead of cP (the calculator converts).

Assumptions and limits

  • Dilute solute; nonelectrolytes.
  • The water association factor is Perry's 2.26; the original Wilke–Chang value 2.6 gives a diffusivity about 7 % higher.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 5
  • Eq. (5-214) and association factors (water 2.26, methanol 1.9, ethanol 1.5, propanol 1.2)

Questions and answers

What is the association factor?

A correction for hydrogen bonding in the solvent: 2.26 for water in Perry's reanalysis.

Which molar volume?

The solute's molar volume as liquid at its normal boiling point (Le Bas volumes are often used).

What do the defaults give?

Ethanol (59.2 cm³/mol) in water at 25 °C: about 1.4 × 10⁻⁵ cm²/s (measured 1.24).

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.