Worked example
Example: Ethyl mercaptan 303.15 K (Perry's example: 22.36 mN/m). The inputs, in the units selected above:
| Input | Value |
|---|---|
| Temperature | 30.000 °C |
| Normal boiling point | 35.000 °C |
| Critical temperature | 226.00 °C |
| Critical pressure | 54.900 bar |
Applying the formula below gives:
| Result | Value |
|---|---|
| Miller factor | 5.1129 |
| Surface tension | 22.360 mN/m |
Open this example in the calculator and change any input.
Formula
\(\sigma = 5.553\times10^{-5}\,p_c^{2/3}T_c^{1/3}F(1 - T_r)^{11/9}\ \mathrm{mN/m}\ (p_c\ \mathrm{Pa}), \quad F = \frac{T_{br}(\ln p_c - 11.5261)}{1 - T_{br}} - 1.3281\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T\) | Temperature | K |
| \(T_b\) | Normal boiling point | K |
| \(T_c\) | Critical temperature | K |
| \(p_c\) | Critical pressure | Pa |
| \(F\) | Miller factor | - |
| \(\sigma\) | Surface tension | N/m |
Method and standards
Brock–Bird–Miller corresponding states.
Where it is used
- Foaming, wetting and packing calculations for organics.
Common mistakes
- Using for water or alcohols.
- Critical pressure in bar (the formula uses Pa; the calculator converts).
Assumptions and limits
- Nonpolar and moderately polar organics.
- Inconsistent critical constants can make the Miller factor zero or negative; the page then stops.
References
- Perry's Chemical Engineers' Handbook
- 9th ed. (McGraw-Hill, 2019)
- sec. 2
- Eqs. (2-118) and (2-119) (Brock and Bird, modified by Miller) with the ethyl mercaptan example
Questions and answers
What does Perry's example give?
Ethyl mercaptan at 303.15 K: 22.36 mN/m, 1.4 % below DIPPR.
When should I use the parachor instead?
When parachor groups and the liquid density are known; Brock–Bird needs only T_b, T_c and p_c.
Why the exponent 11/9?
It follows the near-critical scaling of surface tension with (1 − T_r).
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.