FireCADCalc

Liquid Surface Tension by the Parachor (Macleod–Sugden)

Surface tension of a liquid from its parachor and the liquid and vapour molar densities by the Macleod–Sugden relation σ^¼ = P(ρ_L − ρ_V).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Benzene 20 °CEthyl ether 20 °C

Results

Densities in mol/cm³ in the relation give dyn/cm (= mN/m); the calculator converts from kg/m³.

Surface tension17.016mN/m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Benzene 20 °C. The inputs, in the units selected above:

InputValue
Parachor (cm³·g^¼/(s^½·mol))206.00 -
Liquid density879.00 kg/m³
Vapour density0.30000 kg/m³
Molar mass78.110 kg/kmol

Applying the formula below gives:

ResultValue
Surface tension28.841 mN/m

Open this example in the calculator and change any input.

Formula

\(\sigma^{1/4} = [P](\rho_L - \rho_V)\ \ (\sigma\ \mathrm{dyn/cm};\ \rho\ \mathrm{mol/cm^3})\)

Variables

Symbol Meaning SI unit
\([P]\) Parachor (cm³·g¼/(s½·mol)) -
\(\rho_L\) Liquid density kg/m³
\(\rho_V\) Vapour density kg/m³
\(M\) Molar mass kg/kmol
\(\sigma\) Surface tension N/m

Method and standards

Macleod–Sugden relation.

Where it is used

  • Estimating σ at another temperature from density.

Common mistakes

  • Using mass density without dividing by M.

Assumptions and limits

  • Pure, nonassociated liquids.
  • The fourth power makes the result sensitive to density: the default 876 kg/m³ and the preset's 879 kg/m³ differ by 0.3 % but give 28.5 and 28.8 mN/m.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 2 (surface tension: parachor method of Macleod and Sugden)

Questions and answers

Why the fourth power?

Small errors in parachor or density are multiplied fourfold: 1 % in density gives 4 % in σ.

Where do parachors come from?

Additive group values or a measured surface tension at one temperature.

What do the defaults represent?

Benzene at 20 °C: about 28.5 mN/m with the default density of 876 kg/m³ (28.8 with 879 kg/m³, as in the preset); measured about 28.9 mN/m.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.