FireCADCalc

Heat of Reaction at Temperature (Kirchhoff)

Heat of reaction at a temperature from its value at 25 °C and the change in heat capacity ΔC_p = Δa + Δb T + Δc T² of products minus reactants (Kirchhoff's law).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Ammonia synthesis (illustrative ΔCp), 500 °CConstant ΔCp −10 J/(mol·K), 400 K

Results

ΔC_p at T-21.302
Heat of reaction at T-105.81kJ/mol

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Ammonia synthesis (illustrative ΔCp), 500 °C. The inputs, in the units selected above:

InputValue
Heat of reaction at 25 °C-92.200 kJ/mol
Δa (J/(mol·K))-45.600 -
Δb (J/(mol·K²))0.032200 -
Δc (J/(mol·K³))-1.0000e-06 -
Temperature500.00 °C

Applying the formula below gives:

ResultValue
ΔC_p at T-21.302
Heat of reaction at T-105.81 kJ/mol

Open this example in the calculator and change any input.

Formula

\(\Delta H_T = \Delta H_{298} + \int_{298}^{T}(\Delta a + \Delta bT + \Delta cT^2)\,dT\)

Variables

Symbol Meaning SI unit
\(\Delta H_{298}\) Heat of reaction at 25 °C J/mol
\(\Delta a\) Δa (J/(mol·K)) -
\(\Delta b\) Δb (J/(mol·K²)) -
\(\Delta c\) Δc (J/(mol·K³)) -
\(T\) Temperature K
\(\Delta C_p(T)\) ΔC_p at T -
\(\Delta H_T\) Heat of reaction at T J/mol

Method and standards

Kirchhoff's law integrated.

Where it is used

  • Reactor heat balances at operating temperature.

Common mistakes

  • Mixing per-mole bases.
  • Crossing a phase change without its latent heat.

Assumptions and limits

  • No phase change between 298 K and T. Coefficients in J/(mol·K) with T in kelvin.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 4 and 7 (Kirchhoff's relation for the temperature dependence of the heat of reaction)

Questions and answers

Why does the heat of reaction change with temperature?

Products and reactants heat up differently; the difference ΔC_p accumulates.

How big is the effect?

From a few per cent to over ten per cent over several hundred kelvin, depending on ΔC_p; the default ammonia case moves from −92.2 to about −105.8 kJ/mol (about 15 %) between 25 and 500 °C.

What do the defaults represent?

Ammonia synthesis (N₂ + 3H₂ → 2NH₃) with illustrative ΔC_p coefficients, not taken from a particular table; enter your own.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.