FireCADCalc

Gas Diffusivity by Fuller–Schettler–Giddings

Binary diffusion coefficient of two gases at low pressure from temperature, pressure, molar masses and Fuller diffusion volumes (Perry Eq. 5-202).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Water vapour in air, 25 °CCO2 in N2, 400 K, 2 bar

Fuller atomic and molecular diffusion volumes (Perry's Table 5-12).

Results

Fuller's method averages about 5 % error for nonpolar gases at low pressure (Perry's).

Diffusion coefficient0.25090cm²/s

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Water vapour in air, 25 °C. The inputs, in the units selected above:

InputValue
Temperature25.000 °C
Pressure (absolute)101.33 kPa
Molar mass of A18.015 kg/kmol
Molar mass of B28.960 kg/kmol
Diffusion volume of A13.100 -
Diffusion volume of B19.700 -

Applying the formula below gives:

ResultValue
Diffusion coefficient0.25090 cm²/s

Open this example in the calculator and change any input.

Formula

\(D_{AB} = \frac{10^{-3}\,T^{1.75}\sqrt{1/M_A + 1/M_B}}{p\left[(\Sigma v_A)^{1/3} + (\Sigma v_B)^{1/3}\right]^2}\ \ (\mathrm{cm^2/s};\ T\ \mathrm{K},\ p\ \mathrm{atm})\)

Variables

Symbol Meaning SI unit
\(T\) Temperature K
\(p\) Pressure Pa
\(M_A\) Molar mass of A kg/kmol
\(M_B\) Molar mass of B kg/kmol
\(\Sigma v_A\) Diffusion volume of A -
\(\Sigma v_B\) Diffusion volume of B -
\(D_{AB}\) Diffusion coefficient m²/s

Method and standards

Fuller–Schettler–Giddings correlation.

Where it is used

  • Mass transfer, drying and evaporation calculations.

Common mistakes

  • Using at high pressure.
  • Mixing diffusion volumes from other methods.

Assumptions and limits

  • Low pressure (absolute); nonpolar or weakly polar gases. A note appears above about 10 bar.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 5
  • Eq. (5-202) and Table 5-12 (Fuller, Schettler and Giddings)

Questions and answers

What are diffusion volumes?

Fuller's additive atomic and molecular volumes; for example water 13.1, air 19.7, CO₂ 26.9.

How does it change with temperature and pressure?

Roughly as T^1.75 and 1/p.

What do the defaults give?

Water vapour in air at 25 °C: about 0.25 cm²/s (measured 0.26).

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.