FireCADCalc

Milk Powder Yield from Milk or Concentrate

Powder produced and water removed when milk or concentrate of known total solids is dried to a powder moisture, with powder per 1000 L of milk.

Food, dairy and textile

Inputs

Examples: 100 t whole milk 12.5 %Skim 9 %

Results

Evaporate to 45–50 % solids before the spray dryer: water costs far less to remove there.

Powder18.469t
Water removed181.26t
Powder per 1000 L of feed (milk or concentrate)95.299g/L

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 100 t whole milk 12.5 %. The inputs, in the units selected above:

InputValue
Milk or concentrate100,000 kg
Total solids12.500 %
Powder moisture3.5000 %
Solids losses1.0000 %
Feed density (milk or concentrate)1,032.0 kg/m³

Applying the formula below gives:

ResultValue
Powder12.824 t
Water removed87.051 t
Powder per 1000 L of feed (milk or concentrate)132.34 g/L

Open this example in the calculator and change any input.

Formula

\(M_p = \frac{M\,TS(1 - L)}{1 - w_p}\)

Variables

Symbol Meaning SI unit
\(M\) Milk or concentrate kg
\(TS\) Total solids -
\(w_p\) Powder moisture -
\(L\) Solids losses -
\(\rho\) Milk density kg/m³
\(M_p\) Powder kg
\(M_w\) Water removed kg
\(M_p/V\) Powder per 1000 L of milk kg/m³

Method and standards

Total solids balance.

Where it is used

  • Dairy yield accounting.

Common mistakes

  • Using volume without density.
  • Ignoring losses.

Assumptions and limits

  • Solids conserved except the loss share.
  • The powder per 1000 L refers to the feed entered: for a concentrate it is per 1000 L of concentrate, not of the original milk.

References

  • Mass and energy balances (definitions): total solids balance

Questions and answers

How much powder from 1000 L?

About 130 kg of whole milk powder from milk with 12.5 % solids.

Where do losses occur?

Fines in exhaust air, deposits and start-up, usually 1–2 %.

Why low powder moisture?

Below 4 % keeps powder free-flowing and stable.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.