FireCADCalc

Mash Strike Water Temperature

Temperature of the strike water so that, mixed with the grist, the mash reaches the rest temperature, from grist and water masses and specific heats.

Distillery and ethanolFood, dairy and textile

Inputs

Examples: 10 t grist, 3:1, mash at 65 °CProtein rest 52 °C, 4:1

Results

Mix strike water and grist well in a pre-masher to avoid dough balls and hot spots.

Strike water temperature56.645°C
Liquor-to-grist ratio4.0000kg/kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 t grist, 3:1, mash at 65 °C. The inputs, in the units selected above:

InputValue
Grist10,000 kg
Strike water30,000 kg
Grist temperature18.000 °C
Target mash temperature65.000 °C
Grist specific heat1.6500 kJ/(kg·K)
Allowance for vessel heat loss1.0000 K

Applying the formula below gives:

ResultValue
Strike water temperature72.174 °C
Liquor-to-grist ratio3.0000 kg/kg

Open this example in the calculator and change any input.

Formula

\(T_s = T_m + \frac{M_gc_g(T_m - T_g)}{M_wc_w} + \Delta T_l\)

Variables

Symbol Meaning SI unit
\(M_g\) Grist kg
\(M_w\) Strike water kg
\(T_g\) Grist temperature K
\(T_m\) Target mash temperature K
\(c_g\) Grist specific heat J/(kg·K)
\(\Delta T_l\) Allowance for vessel heat loss K
\(T_s\) Strike water temperature K
\(M_w/M_g\) Liquor-to-grist ratio kg/kg
\(c_w\) Specific heat of water, 4.1868 kJ/(kg·K) J/(kg·K)

Method and standards

Mixing heat balance.

Where it is used

  • Brewing and distillery mashing.

Common mistakes

  • Ignoring vessel heat-up.
  • Using volume without density.

Assumptions and limits

  • No water absorption heat. c_w, the specific heat of water, is 4.1868 kJ/(kg·K).
  • Strike water at or above 100 °C (at atmospheric pressure) is rejected.

References

  • Definitions and mass and energy balances: heat balance of grist and water to the mash temperature

Questions and answers

Why is strike water hotter than the mash?

The cold grist absorbs heat as it mixes.

What liquor-to-grist ratio is usual?

2.5–4 L/kg for infusion and decoction mashes.

What grist specific heat?

About 1.6–1.7 kJ/(kg·K) for dry malt.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.