Worked example
Example: 20 m3/h milk, DN65, 15 s. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Flow | 20.000 m³/h |
| Tube inner diameter | 60.500 mm |
| Minimum holding time | 15.000 s |
| Product density | 1,020.0 kg/m³ |
| Product viscosity | 0.50000 cP |
Applying the formula below gives:
| Result | Value |
|---|---|
| Mean velocity | 1.9325 m/s |
| Reynolds number | 238,513 |
| Fastest-particle factor used | 1.2000 |
| Holding tube length | 34.786 m |
Open this example in the calculator and change any input.
Formula
\(\bar v = \frac{4\dot V}{\pi d^2}, \quad L = k\,\bar v\,t, \quad k = 2\ (Re < 10\,000),\ 1.2\ (Re \ge 10\,000)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V\) | Flow | m³/s |
| \(d\) | Tube inner diameter | m |
| \(t\) | Minimum holding time | s |
| \(\rho\) | Product density | kg/m³ |
| \(\mu\) | Product viscosity | Pa·s |
| \(\bar v\) | Mean velocity | m/s |
| \(Re\) | Reynolds number | - |
| \(v_{max}/\bar v\) | Fastest-particle factor used | - |
| \(L\) | Holding tube length | m |
Method and standards
Residence time of the fastest particle.
Where it is used
- Pasteuriser and UHT holding tube design.
Common mistakes
- Using the mean velocity.
- Ignoring viscosity of creams and mixes.
Assumptions and limits
- Newtonian product; isothermal tube. For non-Newtonian products (cream, purées) the fastest-particle ratio differs from 2 and 1.2; the viscosity input does not make the calculation valid for them, so use the ratio from a validated study.
References
- Mass and energy balances (definitions): fastest-particle velocity 2 × mean in laminar flow (Poiseuille) and about 1.2 × mean in turbulent flow
Questions and answers
Why the factor 2?
In laminar flow the centre-line velocity is twice the mean, so the fastest particle spends half the mean time.
What hold is needed for milk?
At least 15 s at 72 °C (HTST); check your local regulations.
Should the tube slope?
Yes, upward, so it stays full and air is purged.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.