Worked example
Example: 10 t malt, 60 m3 at 12 °P. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Malt (grist) mashed | 10,000 kg |
| Laboratory extract of the malt (as is) | 78.000 % |
| Hot wort volume cast out | 60.000 m³ |
| Wort strength (°Plato = % extract by mass) | 12.000 % |
| Specific gravity of the wort (20/20 °C) | 1.0484 - |
| Hot-to-cold volume factor | 0.96000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Extract in the wort | 7,233.5 kg |
| Brewhouse yield (extract on malt) | 72.335 % |
| Brewhouse efficiency (vs laboratory extract) | 92.737 % |
Open this example in the calculator and change any input.
Formula
\(E = Vk_h\cdot SG\cdot\rho_w\cdot°P, \quad Y_{BH} = \frac{E}{M_m}, \quad \eta = \frac{E}{M_mE_L}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(M_m\) | Malt (grist) mashed | kg |
| \(E_L\) | Laboratory extract of the malt (as is) | - |
| \(V\) | Hot wort volume cast out | m³ |
| \(°P\) | Wort strength (°Plato = % extract by mass) | - |
| \(SG\) | Specific gravity of the wort (20/20 °C) | - |
| \(k_h\) | Hot-to-cold volume factor | - |
| \(E\) | Extract in the wort | kg |
| \(Y_{BH}\) | Brewhouse yield (extract on malt) | - |
| \(\eta\) | Brewhouse efficiency (vs laboratory extract) | - |
Method and standards
Extract balance.
Where it is used
- Brewhouse performance tracking.
Common mistakes
- Using hot volume with cold gravity.
- Mixing as-is and dry lab extract.
Assumptions and limits
- SG measured at 20 °C. °Plato and SG fix each other; a note appears when they disagree by more than 0.002 in SG (common Plato–SG relation), and when the efficiency exceeds 100 %.
References
- Definitions and mass and energy balances: °Plato is extract as % by mass; water density 998.2 kg/m³ at 20 °C
Questions and answers
Why convert hot to cold volume?
Wort shrinks about 4 % from near 100 °C to 20 °C; gravity is measured cold.
What is laboratory extract?
The extract the malt gives in a standard laboratory mash, the brewhouse's target.
What is °Plato?
Grams of extract per 100 g of wort.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.