Worked example
Example: Make-up through PRDS. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crushing rate | 250.00 t/h |
| Process steam % cane | 42.000 % |
| Exhaust from turbines (mill drives and TG) | 90.000 t/h |
| Steam losses (share of generation) | 3.0000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Process steam | 105.00 t/h |
| PRDS make-up (live steam) | 15.000 t/h |
| Surplus exhaust | 0 t/h |
| Boiler steam | 108.25 t/h |
| Boiler steam % cane | 43.299 % |
Open this example in the calculator and change any input.
Formula
\(\dot m_p = C\,s_p, \quad \dot m_{PRDS} = \max(0, \dot m_p - \dot m_t), \quad \dot m_b = \frac{\dot m_t + \dot m_{PRDS}}{1 - k_l}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(C\) | Crushing rate | kg/s |
| \(s_p\) | Process steam % cane | - |
| \(\dot m_t\) | Exhaust from turbines (mill drives and TG) | kg/s |
| \(k_l\) | Steam losses (share of generation) | - |
| \(\dot m_p\) | Process steam | kg/s |
| \(\dot m_{PRDS}\) | PRDS make-up (live steam) | kg/s |
| \(\dot m_x\) | Surplus exhaust | kg/s |
| \(\dot m_b\) | Boiler steam | kg/s |
| \(s_b\) | Boiler steam % cane | - |
Method and standards
Mass balance.
Where it is used
- Cogeneration and process steam planning.
- Steam economy projects.
Common mistakes
- Desuperheating water counted as steam.
Assumptions and limits
- Back-pressure turbines exhaust to process.
- PRDS make-up is counted 1:1 as live steam; the desuperheating water is not modelled, so boiler steam is slightly high when make-up is needed.
References
- Mass balance of live
- exhaust and process steam (Hugot; Rein)
Questions and answers
What is a good steam % cane?
Modern mills with vapour bleeding run well below 40 %; older ones near 50 %.
Why avoid PRDS make-up?
Live steam through a PRDS makes no power; through a turbine it would.
Why avoid surplus exhaust?
It is fuel spent with nowhere to go.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.