Worked example
Example: Hugot figures: 48 -> 8 % moisture. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Bagasse | 30.000 t/h |
| Bagasse moisture | 48.000 % |
| Pellet moisture | 8.0000 % |
| Pelletising energy per tonne of pellets | 80.000 kWh/t |
| Steam per kg of pellets | 4.8000 - |
| Steam per kg of bagasse | 2.2000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Pellets | 16.957 t/h |
| Pellets per kg bagasse | 0.56522 |
| Water removed | 13.043 t/h |
| Pelletising power | 1,356.5 kW |
| Gross steam gain over burning the bagasse (drying heat and pelletising power not deducted) | 23.320 % |
Open this example in the calculator and change any input.
Formula
\(y = \frac{1 - w_0}{1 - w_1}, \quad \dot m_p = yB, \quad P = e\,\dot m_p, \quad \text{gain} = \frac{y\,r_p}{r_b} - 1\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(B\) | Bagasse | kg/s |
| \(w_0\) | Bagasse moisture | - |
| \(w_1\) | Pellet moisture | - |
| \(e\) | Pelletising energy per tonne of pellets | J/kg |
| \(r_p\) | Steam per kg of pellets | - |
| \(r_b\) | Steam per kg of bagasse | - |
| \(\dot m_p\) | Pellets | kg/s |
| \(y\) | Pellets per kg bagasse | - |
| \(\dot m_w\) | Water removed | kg/s |
| \(P\) | Pelletising power | W |
| \(y\,r_p/r_b - 1\) | Gross steam gain over burning the bagasse (drying heat and pelletising power not deducted) | - |
Method and standards
Dry-solids balance with Hugot's figures.
Where it is used
- Surplus bagasse studies.
- Off-season fuel planning.
Common mistakes
- Ignoring drying energy.
- Comparing steam at different conditions.
Assumptions and limits
- Same boiler conditions for both fuels.
- The steam gain is gross: the heat to dry the bagasse (about 0.4 kg of water per kg of bagasse at the defaults) and the pelletising power are not deducted. It is a real gain only if the drying heat would otherwise be wasted (flue gas).
- Steam per kg of pellets and of bagasse are your inputs; the pellet figure is not tied to the pellet moisture.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- preface to the third edition (bagasse pelletisation)
- Dry-solids balance
Questions and answers
Why pelletise?
Dry pellets store well and burn with far more steam per kg; surplus bagasse becomes a saleable fuel.
Where does the drying heat come from?
Usually flue gas from the boilers; the steam gain counts only if the drying heat is otherwise wasted.
How dense are pellets?
Bulk about 720–880 kg/m³, against 120–200 for bagasse.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.