FireCADCalc

Sugar Mill Steam Balance (Process, Exhaust and PRDS Make-up)

Process steam from steam % cane, the PRDS make-up or surplus exhaust against the turbine exhaust available, and boiler steam % cane.

Sugar mill and cogenerationDesuperheater and PRDS

Inputs

Examples: Make-up through PRDSSurplus exhaust

Results

PRDS make-up is counted as live steam kilogram for kilogram; the desuperheating water it picks up (which adds to the exhaust mass) is ignored, so boiler steam is slightly overstated.

Process steam105.00t/h
PRDS make-up (live steam)15.000t/h
Surplus exhaust0t/h
Boiler steam108.25t/h
Boiler steam % cane43.299%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Make-up through PRDS. The inputs, in the units selected above:

InputValue
Crushing rate250.00 t/h
Process steam % cane42.000 %
Exhaust from turbines (mill drives and TG)90.000 t/h
Steam losses (share of generation)3.0000 %

Applying the formula below gives:

ResultValue
Process steam105.00 t/h
PRDS make-up (live steam)15.000 t/h
Surplus exhaust0 t/h
Boiler steam108.25 t/h
Boiler steam % cane43.299 %

Open this example in the calculator and change any input.

Formula

\(\dot m_p = C\,s_p, \quad \dot m_{PRDS} = \max(0, \dot m_p - \dot m_t), \quad \dot m_b = \frac{\dot m_t + \dot m_{PRDS}}{1 - k_l}\)

Variables

Symbol Meaning SI unit
\(C\) Crushing rate kg/s
\(s_p\) Process steam % cane -
\(\dot m_t\) Exhaust from turbines (mill drives and TG) kg/s
\(k_l\) Steam losses (share of generation) -
\(\dot m_p\) Process steam kg/s
\(\dot m_{PRDS}\) PRDS make-up (live steam) kg/s
\(\dot m_x\) Surplus exhaust kg/s
\(\dot m_b\) Boiler steam kg/s
\(s_b\) Boiler steam % cane -

Method and standards

Mass balance.

Where it is used

  • Cogeneration and process steam planning.
  • Steam economy projects.

Common mistakes

  • Desuperheating water counted as steam.

Assumptions and limits

  • Back-pressure turbines exhaust to process.
  • PRDS make-up is counted 1:1 as live steam; the desuperheating water is not modelled, so boiler steam is slightly high when make-up is needed.

References

  • Mass balance of live
  • exhaust and process steam (Hugot; Rein)

Questions and answers

What is a good steam % cane?

Modern mills with vapour bleeding run well below 40 %; older ones near 50 %.

Why avoid PRDS make-up?

Live steam through a PRDS makes no power; through a turbine it would.

Why avoid surplus exhaust?

It is fuel spent with nowhere to go.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.