Worked example
Example: Sugar screw 0.5 m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Material | Sugar |
| Screw diameter | 0.50000 m |
| Pitch | 0.35000 m |
| Speed | 20.000 rpm |
| Fill and slip coefficient | 15.000 % |
| Bulk density | 850.00 kg/m³ |
| Screw length | 20.000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Volume conveyed | 12.370 m³/h |
| Mass conveyed | 10.515 t/h |
| Hugot's speed (10/D sugar, 15/D massecuite) | 20.000 rpm |
| Power (0.8 D²L sugar, 1.15 D²L massecuite) | 4.0000 kW |
Open this example in the calculator and change any input.
Formula
\(\dot V = \frac{\pi D^2}{4}p\,n\,k, \quad \dot m = d\dot V, \quad P = 0.8D^2L\ (\text{sugar}),\ 1.15D^2L\ (\text{massecuite})\ [\mathrm{kW}]\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{material}\) | Material | - |
| \(D\) | Screw diameter | m |
| \(p\) | Pitch | m |
| \(n\) | Speed | 1/s |
| \(k\) | Fill and slip coefficient | - |
| \(d\) | Bulk density | kg/m³ |
| \(L\) | Screw length | m |
| \(\dot V\) | Volume conveyed | m³/s |
| \(\dot m\) | Mass conveyed | kg/s |
| \(n_H\) | Hugot's speed (10/D sugar, 15/D massecuite) | 1/s |
| \(P\) | Power (0.8 D²L sugar, 1.15 D²L massecuite) | W |
Method and standards
Hugot's screw conveyor rules.
Where it is used
- Sizing sugar and massecuite screws.
- Checking conveyor power.
Common mistakes
- Using k = 1.
- Forgetting drive losses.
Assumptions and limits
- Horizontal screws.
- Hugot's power rule depends on size only, not on speed or throughput; a speed well above his n_H is flagged.
- The bulk density is not changed with the material: enter about 1 450–1 500 kg/m³ for massecuite.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 35
- screw conveyors for massecuite and sugar
- eqns 35.57–35.61
- pp. 812–814
Questions and answers
What is k?
The share of the swept volume actually moved: the trough is never full and material slips back.
Why do screws crush sugar?
Crystals caught between flight and trough break; Hugot prefers grasshopper conveyors for sugar.
Massecuite speed?
Slow: Tromp recommends 7–8 rpm to avoid back-flow.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.