FireCADCalc

Cane Yard Area from Stock and Bulk Density

Yard area to stack a cane stock at a bulk density and stack height, with an allowance for roads and handling space; bulk densities from Hugot ch. 1.

Sugar mill and cogeneration

Inputs

Examples: 3750 t at 300 kg/m3Loose cane, low stacks

Hugot ch. 1: grab-loaded 200, carefully loaded 300, hand bundles 350–400, chopped cane 300–380 kg/m³.
The rest is roads, cranes and turning space.

Results

Stack volume10,000m³
Area under cane4,000.0m²
Gross yard area8,000.0m²

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 3750 t at 300 kg/m3. The inputs, in the units selected above:

InputValue
Cane stock3,750.0 t
Bulk density of the stacked cane300.00 kg/m³
Mean stack height3.0000 m
Share of the yard area that holds cane60.000 %

Applying the formula below gives:

ResultValue
Stack volume12,500 m³
Area under cane4,166.7 m²
Gross yard area6,944.4 m²

Open this example in the calculator and change any input.

Formula

\(V = \frac{P}{\rho_b}, \quad A_n = \frac{V}{H}, \quad A_g = \frac{A_n}{u}\)

Variables

Symbol Meaning SI unit
\(P\) Cane stock kg
\(\rho_b\) Bulk density of the stacked cane kg/m³
\(H\) Mean stack height m
\(u\) Share of the yard area that holds cane -
\(V\) Stack volume m³
\(A_n\) Area under cane m²
\(A_g\) Gross yard area m²

Method and standards

Mass, volume and area for a stack of mean height H.

Where it is used

  • Laying out cane yards.
  • Checking yard capacity for a crush expansion.

Common mistakes

  • Using the density of cane in trucks for loose stacks.
  • Taking the peak stack height as the mean height.

Assumptions and limits

  • Mean stack height over the whole cane area. A note appears for a bulk density outside Hugot's 200–400 kg/m³.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 1
  • bulk densities of cane
  • p. 1

Questions and answers

Which bulk density?

It depends on how the cane is loaded: Hugot gives about 200 kg/m³ for grab-loaded whole cane and 300–380 for chopped cane.

Why an allowance for roads?

Cranes, unloaders and vehicles need room; often only half to two-thirds of the yard holds cane.

Does the stack height matter?

Yes: area falls in proportion, but high stacks crush the bottom cane and slow unloading.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.