Worked example
Example: 2 L between 100 and 200 bar, 90 bar pre-charge, adiabatic. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Oil volume to deliver | 2.0000 L |
| Gas pre-charge pressure (gauge) | 90.000 bar |
| Minimum working pressure (gauge) | 100.00 bar |
| Maximum working pressure (gauge) | 200.00 bar |
| Polytropic exponent (1 isothermal, 1.4 adiabatic nitrogen) | 1.4000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Accumulator gas volume | 5.5488 L |
| Gas volume if isothermal (n = 1) | 4.4620 L |
Open this example in the calculator and change any input.
Formula
\(V_0 = \frac{\Delta V}{\left(\dfrac{p_0}{p_1}\right)^{1/n} - \left(\dfrac{p_0}{p_2}\right)^{1/n}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\Delta V\) | Oil volume to deliver | m³ |
| \(p_0\) | Gas pre-charge pressure (gauge) | Pa |
| \(p_1\) | Minimum working pressure (gauge) | Pa |
| \(p_2\) | Maximum working pressure (gauge) | Pa |
| \(n\) | Polytropic exponent (1 isothermal, 1.4 adiabatic nitrogen) | - |
| \(V_0\) | Accumulator gas volume | m³ |
| \(V_{0,iso}\) | Gas volume if isothermal (n = 1) | m³ |
Method and standards
Polytropic gas law between the two pressures.
Where it is used
- Emergency and pulsation accumulators.
- Power unit design.
Common mistakes
- Gauge pressures in the ratio.
- Pre-charge above minimum pressure.
Assumptions and limits
- Ideal gas.
- One exponent n from pre-charge to p₁ and on to p₂. Makers often treat pre-charge and slow filling as isothermal and only a fast discharge as adiabatic; the isothermal result V₀,iso and the adiabatic V₀ bracket that mixed case.
References
- Boyle's law and polytropic gas compression p Vⁿ = constant
Questions and answers
2 L between 100 and 200 bar with 90 bar pre-charge, fast discharge?
About 5.5 L of gas volume (n = 1.4); 4.5 L if slow (isothermal).
Why absolute pressures?
Boyle's law works on absolute pressure.
Why does speed matter?
Fast cycles do not exchange heat, so the gas behaves adiabatically and delivers less.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.