Worked example
Example: 50 kg sheet, 80 mm cups, horizontal. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Load mass | 50.000 kg |
| Vacuum (below atmospheric) | 60.000 kPa |
| Cup diameter | 80.000 mm |
| Acceleration of the handling motion | 5.0000 m/s² |
| Lift orientation | Horizontal surface, vertical lift |
| Cup–load friction coefficient | 0.50000 - |
| Safety factor | 2.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Theoretical force per cup | 301.59 N |
| Required total force | 1,480.7 N |
| Cups needed (rounded up) | 5.0000 |
Open this example in the calculator and change any input.
Formula
\(F_c = \Delta p\frac{\pi d^2}{4}, \quad F_{req} = m(g + a)S\ \text{(horizontal)}, \ \frac{m(g + a)S}{\mu}\ \text{(vertical)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Load mass | kg |
| \(\Delta p\) | Vacuum (below atmospheric) | Pa |
| \(d\) | Cup diameter | m |
| \(a\) | Acceleration of the handling motion | m/s² |
| \(\text{orientation}\) | Lift orientation | - |
| \(g\) | Standard gravity, 9.80665 | m/s² |
| \(\mu\) | Cup–load friction coefficient | - |
| \(S\) | Safety factor | - |
| \(F_c\) | Theoretical force per cup | N |
| \(F_{req}\) | Required total force | N |
| \(n\) | Cups needed (rounded up) | - |
Method and standards
Statics.
Where it is used
- Pick-and-place and sheet handling.
- Vacuum lifters.
Common mistakes
- Ignoring acceleration.
- Using theoretical force for porous loads.
Assumptions and limits
- Sealed cups; rigid load.
References
- Pressure × area and friction statics (definitions)
Questions and answers
Why does orientation matter so much?
On a vertical surface the cups hold by friction alone: with μ = 0.5 you need twice the force.
What vacuum is practical?
60–80 kPa below atmosphere with ejectors; less for porous materials.
What do the defaults represent?
A 50 kg sheet lifted horizontally with 80 mm cups at 60 kPa vacuum.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.