Worked example
Example: 100 mm bore, 56 mm rod, 160 bar, 60 L/min. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Bore | 100.00 mm |
| Rod diameter | 56.000 mm |
| Working pressure | 160.00 bar |
| Pump flow | 60.000 L/min |
| Mechanical (seal) efficiency | 95.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Push (extend) force | 119.38 kN |
| Pull (retract) force | 81.943 kN |
| Extend speed | 7.6394 m/min |
| Retract speed | 11.130 m/min |
| Area ratio A/(A − a) | 1.4569 |
Open this example in the calculator and change any input.
Formula
\(F_e = p\,\frac{\pi D^2}{4}\eta_m, \quad F_r = p\,\frac{\pi (D^2 - d^2)}{4}\eta_m, \quad v = \frac{Q}{A}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Bore | m |
| \(d\) | Rod diameter | m |
| \(p\) | Working pressure | Pa |
| \(Q\) | Pump flow | m³/s |
| \(\eta_m\) | Mechanical (seal) efficiency | - |
| \(F_e\) | Push (extend) force | N |
| \(F_r\) | Pull (retract) force | N |
| \(v_e\) | Extend speed | m/s |
| \(v_r\) | Retract speed | m/s |
| \(\varphi\) | Area ratio A/(A − a) | - |
Method and standards
Pressure times area; continuity.
Where it is used
- Press, crane and machine hydraulics.
- Selecting cylinders.
Common mistakes
- Gauge supply pressure with back pressure ignored.
- Forgetting the rod area on retract.
Assumptions and limits
- Steady motion.
References
- F = p A; v = Q/A (fluid power basics); ISO 6020/6022 give standard bore and rod sizes
- which are not checked here
Questions and answers
100 mm bore, 56 mm rod at 160 bar?
Push 119 kN, pull 82 kN.
How fast with 60 L/min?
Extend 7.6 m/min, retract 11.1 m/min.
Why is retract faster?
The rod takes up part of the area, so the same flow moves the piston further.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.