FireCADCalc

Pilling–Bedworth Ratio of an Oxide

Pilling–Bedworth ratio of an oxide (oxide volume per volume of metal consumed) from molar masses and densities, indicating whether the scale is protective.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: Al → Al₂O₃Fe → Fe₂O₃Mg → MgO

Results

Below 1 the oxide cannot cover the metal (porous, e.g. Mg); 1–2 tends to be protective (Al, Cr, Ni); above 2 compressive stresses crack and spall the scale (Fe₂O₃ about 2.1). Diffusion through the scale matters as much as PBR.

Pilling–Bedworth ratio1.2916
Scale class (0 porous, 1 protective, 2 spalling)1.0000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Al → Al₂O₃. The inputs, in the units selected above:

InputValue
Oxide molar mass101.96 kg/kmol
Oxide density3,950.0 kg/m³
Metal molar mass26.980 kg/kmol
Metal density2,700.0 kg/m³
Metal atoms per oxide formula2.0000 -

Applying the formula below gives:

ResultValue
Pilling–Bedworth ratio1.2916
Scale class (0 porous, 1 protective, 2 spalling)1.0000

Open this example in the calculator and change any input.

Formula

\(PBR = \frac{M_{ox}\rho_m}{nM_m\rho_{ox}}\)

Variables

Symbol Meaning SI unit
\(M_{ox}\) Oxide molar mass kg/kmol
\(\rho_{ox}\) Oxide density kg/m³
\(M_m\) Metal molar mass kg/kmol
\(\rho_m\) Metal density kg/m³
\(n\) Metal atoms per oxide formula -
\(PBR\) Pilling–Bedworth ratio -
\(\text{class}\) Scale class (0 porous, 1 protective, 2 spalling) -

Method and standards

Volume ratio.

Where it is used

  • High-temperature alloy selection.
  • Teaching oxidation.

Common mistakes

  • Wrong n (metal atoms per formula).
  • Treating PBR as a rate.

Assumptions and limits

  • Dense oxide; no porosity.

References

  • Pilling and Bedworth (1923)
  • J. Inst. Metals 29: 529

Questions and answers

Why does the ratio matter?

It shows whether the oxide fills, under-fills or over-fills the space of the metal it replaced.

Is a ratio of 1–2 always protective?

No: it is necessary rather than sufficient; scale adhesion and ion diffusion also count.

What do the defaults represent?

Aluminium forming Al₂O₃.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.