Worked example
Example: 2205 duplex. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Chromium (wt %) | 22.000 % |
| Molybdenum (wt %) | 3.0000 % |
| Tungsten (wt %) | 0 % |
| Nitrogen (wt %) | 0.17000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| PREN (16N) | 34.620 |
| PREN (30N) | 37.000 |
Open this example in the calculator and change any input.
Formula
\(PREN = Cr + 3.3(Mo + 0.5W) + 16N\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(Cr\) | Chromium (wt %) | - |
| \(Mo\) | Molybdenum (wt %) | - |
| \(W\) | Tungsten (wt %) | - |
| \(N\) | Nitrogen (wt %) | - |
| \(PREN_{16}\) | PREN (16N) | - |
| \(PREN_{30}\) | PREN (30N) | - |
Method and standards
Weighted composition index.
Where it is used
- Selecting stainless grades for cooling water and seawater.
- Comparing heats against a minimum PREN.
Common mistakes
- Using nominal instead of actual heat analysis.
- Treating PREN as a corrosion rate.
Assumptions and limits
- Wrought stainless steels and nickel alloys.
References
- PREN = Cr + 3.3(Mo + 0.5W) + 16N (wt %)
- the form used in ISO 15156-3 and duplex grade definitions
Questions and answers
What PREN do I need for seawater?
Commonly 40 or more (super duplex, 6Mo austenitic) for ambient seawater without crevice problems.
Why is nitrogen weighted so heavily?
Nitrogen strongly stabilises the passive film in austenite; 16 (or 30 for austenitics) reflects that.
What do the defaults represent?
A 2205 duplex stainless steel: 22 % Cr, 3 % Mo, 0.17 % N.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.