FireCADCalc

Angle Unit Converter (degrees, radians, minutes, gradians)

Convert an angle between radians, degrees, arcminutes, arcseconds, gradians (gons) and revolutions, as used in surveying, machining and trigonometry.

Inputs

Examples: One radianA right angle

Results

In degrees, minutes and seconds: 90° 0′ 0″. The minute and second outputs above are totals, not components.

A full turn is 2π rad = 360° = 400 gon.

radian1.5708rad
degree90.000°
arcminute5,400.0′
arcsecond324,000″
gradian (gon)100.00gon
revolution0.25000rev

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: One radian. The inputs, in the units selected above:

InputValue
Angle (choose its unit)1.0000 rad

Applying the formula below gives:

ResultValue
radian1.0000 rad
degree57.296 °
arcminute3,437.7 ′
arcsecond206,265 ″
gradian (gon)63.662 gon
revolution0.15915 rev

Open this example in the calculator and change any input.

Formula

\(x_{\text{unit}} = \frac{x_{SI}}{f_{\text{unit}}}\)

Variables

Symbol Meaning SI unit
\(x\) Angle (choose its unit) rad

Method and standards

Each unit's factor to the SI unit is held once in the unit registry.

Where it is used

  • Reading foreign drawings and data sheets.
  • Examinations and everyday engineering.

Common mistakes

  • Mixing similar units (US and imperial).
  • Rounding factors too early.

Assumptions and limits

  • Exact factors where the definition is exact.
  • The arcminute and arcsecond outputs are totals; the note gives the angle as degrees, minutes and seconds.

References

  • Unit definitions per NIST SP 811 and the SI Brochure (exact where defined)

Questions and answers

1 radian?

About 57.2958°.

A gradian?

1/400 of a turn: 0.9°.

Degrees-minutes-seconds?

Each degree has 60′, each minute 60″.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.