Worked example
Example: 50 mm diameter, 100 mm long, 100 turns; 1 mH wanted. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Coil diameter (to the centre of the wire) | 50.000 mm |
| Coil length | 100.00 mm |
| Number of turns | 100.00 - |
| Inductance wanted (to find the turns) | 1.0000 mH |
Applying the formula below gives:
| Result | Value |
|---|---|
| Inductance | 200.87 µH |
| Turns for the inductance wanted (same diameter and length) | 223.12 |
| Length to radius ratio | 4.0000 |
Open this example in the calculator and change any input.
Formula
\(L\,[\mu\text{H}] = \frac{r^2 N^2}{9 r + 10 l} \quad (r,\ l\ \text{in inches}), \qquad N_t = \sqrt{\frac{L_t (9r + 10l)}{r^2}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d\) | Coil diameter (to the centre of the wire) | m |
| \(l\) | Coil length | m |
| \(N\) | Number of turns | - |
| \(L_t\) | Inductance wanted (to find the turns) | H |
| \(L\) | Inductance | H |
| \(N_t\) | Turns for the inductance wanted (same diameter and length) | - |
| \(l/r\) | Length to radius ratio | - |
Method and standards
Wheeler's 1928 empirical fit to the exact current-sheet solution.
Where it is used
- Chokes and RF coils.
- Induction and test coils.
Common mistakes
- Using diameter for radius.
- Applying it to iron-cored coils.
Assumptions and limits
- Single layer, air core, l > 0.8 r.
References
- H.A. Wheeler
- Simple inductance formulas for radio coils
- Proc. IRE 16 (1928) 1398
Questions and answers
What is the inductance of 100 turns, 50 mm diameter, 100 mm long?
201 µH.
How accurate is it?
Within about 1 % when the length is more than 0.8 of the radius.
Does wire size matter?
Not in this formula; it treats the winding as a thin current sheet.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.