Worked example
Example: N 18 at 8 m, safety hammer. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Field blow count | 18.000 - |
| Hammer energy ratio | 60.000 % |
| Borehole diameter correction | 1.0000 - |
| Sampler correction | 1.0000 - |
| Rod length correction | 0.95000 - |
| Effective overburden stress | 80.000 kPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Energy-corrected N | 17.100 |
| Overburden correction factor | 1.1254 |
| Normalised N | 19.245 |
Open this example in the calculator and change any input.
Formula
\(N_{60} = N\frac{E_r}{0.6}C_BC_SC_R, \quad (N_1)_{60} = C_NN_{60}, \quad C_N = \sqrt{\frac{p_a}{\sigma'_v}} \le 1.7\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(N\) | Field blow count | - |
| \(E_r\) | Hammer energy ratio | - |
| \(C_B\) | Borehole diameter correction | - |
| \(C_S\) | Sampler correction | - |
| \(C_R\) | Rod length correction | - |
| \(\sigma'_v\) | Effective overburden stress | Pa |
| \(N_{60}\) | Energy-corrected N | - |
| \(C_N\) | Overburden correction factor | - |
| \((N_1)_{60}\) | Normalised N | - |
| \(p_a\) | Atmospheric pressure, 101 325 | Pa |
Method and standards
Skempton and Liao–Whitman.
Where it is used
- Site investigation reports.
- Liquefaction screening.
Common mistakes
- Using total instead of effective stress.
- Applying corrections twice.
Assumptions and limits
- Sands; standard SPT procedure.
- p_a is taken as one standard atmosphere, 101.325 kPa. Many texts write Liao–Whitman with p_a = 100 kPa (or 1 tsf); that gives C_N about 0.66 % lower.
References
- Skempton (1986) energy and equipment corrections; Liao and Whitman (1986) overburden correction (Das, Principles of Foundation Engineering, 7th ed. (Cengage, 2011), ch. 2)
Questions and answers
Why correct N at all?
Different hammers deliver different energy, and the same sand gives higher N under more overburden; corrections make values comparable.
Where is (N₁)₆₀ used?
In correlations for friction angle, relative density and liquefaction resistance.
What do the defaults represent?
A blow count of 18 at about 8 m depth with a safety hammer.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.