Worked example
Example: 500 kN, 3 m deep, 1.5 m off. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Point load | 500.00 kN |
| Depth | 3.0000 m |
| Radial distance from the load line | 1.5000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Influence factor (3/2π)/(1 + (r/z)²)^{5/2} | 0.27332 |
| Vertical stress increase | 15.184 kPa |
Open this example in the calculator and change any input.
Formula
\(\Delta\sigma_z = \frac{3P}{2\pi z^2}\left[1 + \left(\frac{r}{z}\right)^2\right]^{-5/2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Point load | N |
| \(z\) | Depth | m |
| \(r\) | Radial distance from the load line | m |
| \(I_B\) | Influence factor (3/2π)/(1 + (r/z)²)^{5/2} | - |
| \(\Delta\sigma_z\) | Vertical stress increase | Pa |
Method and standards
Elastic half-space.
Where it is used
- Stress under machine and tank loads.
- Settlement input.
Common mistakes
- Using it at very shallow depth.
- Ignoring nearby loads.
Assumptions and limits
- Homogeneous isotropic elastic half-space.
References
- Boussinesq (1885) elastic half-space solution
Questions and answers
500 kN at 3 m depth, 1.5 m off the line?
I_B 0.2733: about 15.2 kPa.
Footings?
Split them into point loads, or use a rectangular-area solution.
Is the soil really elastic?
No, but stress increase is reasonably predicted.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.