FireCADCalc

Infinite Slope Stability: Factor of Safety

Factor of safety of a long natural slope against shallow sliding from slope angle, depth, soil strength and the water table (dry, partly or fully seeping).

Inputs

Examples: 25 degrees, half saturatedDry sand 30 on 35Full seepage clay

0 dry, 1 seepage at the surface, parallel to the slope.

Results

Uses the soil's single unit weight above and below the water table; for slope design use a full slope stability method.

Shear stress on the plane21.832kPa
Effective normal stress34.737kPa
Factor of safety1.2232

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 25 degrees, half saturated. The inputs, in the units selected above:

InputValue
Slope angle25.000 °
Depth of the slip plane3.0000 m
Effective cohesion5.0000 kPa
Effective friction angle32.000 °
Unit weight of the soil19.000 kN/m³
Height of the water table above the slip plane, share of z50.000 %

Applying the formula below gives:

ResultValue
Shear stress on the plane21.832 kPa
Effective normal stress34.737 kPa
Factor of safety1.2232

Open this example in the calculator and change any input.

Formula

\(FS = \frac{c' + (\gamma z \cos^2\beta - m z \gamma_w \cos^2\beta)\tan\phi'}{\gamma z \sin\beta\cos\beta}\)

Variables

Symbol Meaning SI unit
\(\beta\) Slope angle rad
\(z\) Depth of the slip plane m
\(c'\) Effective cohesion Pa
\(\phi'\) Effective friction angle rad
\(\gamma\) Unit weight of the soil N/m³
\(m\) Height of the water table above the slip plane, share of z -
\(\tau\) Shear stress on the plane Pa
\(\sigma'_n\) Effective normal stress Pa
\(FS\) Factor of safety -

Method and standards

Limit equilibrium on a plane parallel to the slope.

Where it is used

  • Cut and natural slopes.
  • Ash pond and coal yard slopes.

Common mistakes

  • Ignoring pore pressure.
  • Using it for short slopes.

Assumptions and limits

  • Long uniform slope.

References

  • Infinite slope analysis with slope-parallel seepage (Das; Duncan and Wright, Soil Strength and Slope Stability)

Questions and answers

25° slope, 3 m deep, c' 5 kPa, φ' 32°, half saturated?

FS about 1.22 with the default 19 kN/m³.

Dry cohesionless slope?

FS = tan φ'/tan β, independent of depth.

Full seepage?

FS roughly halves for sands.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.