FireCADCalc

Relative Density (Density Index) of Sand

Relative density of a sand from its in-place void ratio or dry density and its maximum and minimum, with the usual description from very loose to very dense.

Inputs

Examples: Medium denseVery looseLooseVery dense

Results

Description: very loose (bands 15, 35, 65 and 85 %).

Relative density11.765%
Description (1 very loose … 5 very dense)1.0000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Medium dense. The inputs, in the units selected above:

InputValue
In-place dry density1,650.0 kg/m³
Minimum dry density (loosest)1,500.0 kg/m³
Maximum dry density (densest)1,800.0 kg/m³

Applying the formula below gives:

ResultValue
Relative density54.545 %
Description (1 very loose … 5 very dense)3.0000

Open this example in the calculator and change any input.

Formula

\(D_r = \frac{e_{max} - e}{e_{max} - e_{min}} = \frac{\rho_{d,max}}{\rho_d}\cdot\frac{\rho_d - \rho_{d,min}}{\rho_{d,max} - \rho_{d,min}}\)

Variables

Symbol Meaning SI unit
\(\rho_d\) In-place dry density kg/m³
\(\rho_{d,min}\) Minimum dry density (loosest) kg/m³
\(\rho_{d,max}\) Maximum dry density (densest) kg/m³
\(D_r\) Relative density -
\(\text{state}\) Description (1 very loose … 5 very dense) -

Method and standards

Definition.

Where it is used

  • Sand fills and foundations.
  • Liquefaction screening.

Common mistakes

  • Linear interpolation of densities.
  • Using it for cohesive soils.

Assumptions and limits

  • Clean sands.
  • The in-place density should lie between the minimum and maximum; outside that range D_r falls below 0 or above 100 % and the page warns.

References

  • Relative density D_r = (e_max − e)/(e_max − e_min)
  • written in dry densities (ASTM D4254 definition); bands after Lambe and Whitman

Questions and answers

1650 in place between 1500 and 1800?

D_r = 54.5 %: medium dense.

Why not a simple ratio of densities?

D_r is defined on void ratio, which gives the factor ρmax/ρd.

For clays?

No; relative density applies to free-draining sands.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.