Worked example
Example: Medium dense. The inputs, in the units selected above:
| Input | Value |
|---|---|
| In-place dry density | 1,650.0 kg/m³ |
| Minimum dry density (loosest) | 1,500.0 kg/m³ |
| Maximum dry density (densest) | 1,800.0 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Relative density | 54.545 % |
| Description (1 very loose … 5 very dense) | 3.0000 |
Open this example in the calculator and change any input.
Formula
\(D_r = \frac{e_{max} - e}{e_{max} - e_{min}} = \frac{\rho_{d,max}}{\rho_d}\cdot\frac{\rho_d - \rho_{d,min}}{\rho_{d,max} - \rho_{d,min}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\rho_d\) | In-place dry density | kg/m³ |
| \(\rho_{d,min}\) | Minimum dry density (loosest) | kg/m³ |
| \(\rho_{d,max}\) | Maximum dry density (densest) | kg/m³ |
| \(D_r\) | Relative density | - |
| \(\text{state}\) | Description (1 very loose … 5 very dense) | - |
Method and standards
Definition.
Where it is used
- Sand fills and foundations.
- Liquefaction screening.
Common mistakes
- Linear interpolation of densities.
- Using it for cohesive soils.
Assumptions and limits
- Clean sands.
- The in-place density should lie between the minimum and maximum; outside that range D_r falls below 0 or above 100 % and the page warns.
References
- Relative density D_r = (e_max − e)/(e_max − e_min)
- written in dry densities (ASTM D4254 definition); bands after Lambe and Whitman
Questions and answers
1650 in place between 1500 and 1800?
D_r = 54.5 %: medium dense.
Why not a simple ratio of densities?
D_r is defined on void ratio, which gives the factor ρmax/ρd.
For clays?
No; relative density applies to free-draining sands.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.