FireCADCalc

Seepage Flow by Darcy's Law

Seepage flow, discharge velocity and seepage velocity through a soil from permeability, hydraulic gradient (head loss over length), area and porosity.

Inputs

Examples: Sand bundClay linerGravel

Results

Hydraulic gradient Δh/L0.005000
Discharge (Darcy) velocity k i5.0000e-05m/s
Seepage velocity v/n1.6667e-04m/s
Seepage flow86.400m³/d

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Sand bund. The inputs, in the units selected above:

InputValue
Coefficient of permeability1.0000e-05 m/s
Head loss3.0000 m
Flow length15.000 m
Flow cross-section50.000 m²
Porosity35.000 %

Applying the formula below gives:

ResultValue
Hydraulic gradient Δh/L0.20000
Discharge (Darcy) velocity k i2.0000e-06 m/s
Seepage velocity v/n5.7143e-06 m/s
Seepage flow8.6400 m³/d

Open this example in the calculator and change any input.

Formula

\(i = \frac{\Delta h}{L}, \quad v = k i, \quad v_s = \frac{v}{n}, \quad Q = k i A\)

Variables

Symbol Meaning SI unit
\(k\) Coefficient of permeability m/s
\(\Delta h\) Head loss m
\(L\) Flow length m
\(A\) Flow cross-section m²
\(n\) Porosity -
\(i\) Hydraulic gradient Δh/L -
\(v\) Discharge (Darcy) velocity k i m/s
\(v_s\) Seepage velocity v/n m/s
\(Q\) Seepage flow m³/s

Method and standards

Darcy's law.

Where it is used

  • Dewatering and seepage estimates.
  • Contaminant travel time.

Common mistakes

  • Using seepage velocity for flow.
  • Gross area vs pore area confusion.

Assumptions and limits

  • Laminar, saturated, homogeneous.
  • The seepage velocity uses the porosity entered. For contaminant travel time use the effective (connected) porosity, usually smaller than the total, which gives a faster travel.

References

  • Darcy's law Q = k i A

Questions and answers

k 1e-5 m/s, 3 m over 15 m, 50 m²?

Gradient 0.2, flow 8.6 m³/day.

Why is seepage velocity higher?

Water moves only through the pores.

Turbulent flow?

Darcy's law needs laminar flow; true for most soils.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.