FireCADCalc

Bulking of Sand: Volume Correction for Batching by Volume

Bulking of damp sand from a cylinder test (damp and inundated heights), and the extra sand volume to batch so the mix gets its intended dry sand.

Inputs

Examples: 200 mm damp, 165 mm floodedSlightly dampDry sand, no bulking

Results

Bulking (h₁ − h₂)/h₂0%
Damp sand volume to batch V(1 + β)2.0000m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 200 mm damp, 165 mm flooded. The inputs, in the units selected above:

InputValue
Height of damp sand in the container200.00 mm
Height after flooding with water (inundated)165.00 mm
Sand volume required by the mix (dry, loose)0.50000 m³

Applying the formula below gives:

ResultValue
Bulking (h₁ − h₂)/h₂21.212 %
Damp sand volume to batch V(1 + β)0.60606 m³

Open this example in the calculator and change any input.

Formula

\(\beta = \frac{h_1 - h_2}{h_2}, \quad V_b = V(1 + \beta)\)

Variables

Symbol Meaning SI unit
\(h_1\) Height of damp sand in the container m
\(h_2\) Height after flooding with water (inundated) m
\(V\) Sand volume required by the mix (dry, loose) m³
\(\beta\) Bulking (h₁ − h₂)/h₂ -
\(V_b\) Damp sand volume to batch V(1 + β) m³

Method and standards

Volume ratio of damp to inundated sand.

Where it is used

  • Volume batching of mortar and concrete.
  • Site quality checks.

Common mistakes

  • Using the damp height as base.
  • Ignoring bulking in plaster mixes.

Assumptions and limits

  • Field test.
  • The inundated volume stands in for the dry loose volume of the mix design (flooded sand occupies about the same volume as dry sand), so V is the dry, loose volume and the damp volume to batch is V(1 + β).

References

  • Field method for bulking of sand (IS 2386 Part 3 principle)

Questions and answers

200 mm damp, 165 mm inundated?

Bulking 21.2 %: batch 0.606 m³ of damp sand for 0.5 m³ dry.

Why does damp sand bulk?

Water films push the grains apart; flooded sand settles back.

Does batching by weight avoid it?

Yes, then correct for moisture instead.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.