Worked example
Example: Bent-up bar 16 mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Sum of the straight lengths (outside dimensions) | 4.8000 m |
| Bar diameter | 16.000 mm |
| Number of 45° bends | 2.0000 - |
| Number of 90° bends | 2.0000 - |
| Number of hooks | 0 - |
| Deduction per 45° bend (× d) | 1.0000 - |
| Deduction per 90° bend (× d) | 2.0000 - |
| Length per hook (× d) | 9.0000 - |
| Number of bars | 20.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Cutting length of one bar | 4.7040 m |
| Total length | 94.080 m |
| Total mass (steel 7850 kg/m³) | 148.49 kg |
Open this example in the calculator and change any input.
Formula
\(L_c = \Sigma L - (n_{45} k_{45} + n_{90} k_{90}) d + n_h k_h d, \quad L_t = n L_c, \quad m = 7850\ \mathrm{kg/m^3} \cdot L_t\,\frac{\pi d^2}{4}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\Sigma L\) | Sum of the straight lengths (outside dimensions) | m |
| \(d\) | Bar diameter | m |
| \(n_{45}\) | Number of 45° bends | - |
| \(n_{90}\) | Number of 90° bends | - |
| \(n_h\) | Number of hooks | - |
| \(k_{45}\) | Deduction per 45° bend (× d) | - |
| \(k_{90}\) | Deduction per 90° bend (× d) | - |
| \(k_h\) | Length per hook (× d) | - |
| \(n\) | Number of bars | - |
| \(L_c\) | Cutting length of one bar | m |
| \(L_t\) | Total length | m |
| \(m\) | Total mass (steel 7850 kg/m³) | kg |
Method and standards
Bar bending schedule rule.
Where it is used
- Bar bending schedules.
- Steel ordering.
Common mistakes
- Adding instead of deducting at bends.
- Hooks forgotten.
Assumptions and limits
- Values from the detailing standard; the defaults (1 d, 2 d, 9 d) are common site rules that depend on bend radius and code.
- There is no separate 135° bend (stirrup hook) input: fold its allowance into the hook length k_h.
- Steel density 7 850 kg/m³.
References
- Cutting length = straight lengths − bend deductions + hooks (bar bending schedule practice)
Questions and answers
4.8 m of outside dimensions, 16 mm bar, two 45° and two 90° bends?
4.704 m cutting length.
Why deduct at bends?
Outside dimensions overstate the bar along the inside of the bend.
Which values?
Your standard's: they depend on bend radius.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.