FireCADCalc

Surface Tension by Corresponding States (Brock–Bird)

Surface tension of a nonpolar or moderately polar organic liquid from its critical temperature, critical pressure and normal boiling point (Brock–Bird).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Ethyl mercaptan 303.15 K (Perry's example: 22.36 mN/m)Benzene 293.15 K

Results

Perry's: about 5 %; not for strongly polar or hydrogen-bonded liquids (water, alcohols, acids). Estimate for design; use measured data where they exist.

Miller factor5.2296
Surface tension28.060mN/m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Ethyl mercaptan 303.15 K (Perry's example: 22.36 mN/m). The inputs, in the units selected above:

InputValue
Temperature30.000 °C
Normal boiling point35.000 °C
Critical temperature226.00 °C
Critical pressure54.900 bar

Applying the formula below gives:

ResultValue
Miller factor5.1129
Surface tension22.360 mN/m

Open this example in the calculator and change any input.

Formula

\(\sigma = 5.553\times10^{-5}\,p_c^{2/3}T_c^{1/3}F(1 - T_r)^{11/9}\ \mathrm{mN/m}\ (p_c\ \mathrm{Pa}), \quad F = \frac{T_{br}(\ln p_c - 11.5261)}{1 - T_{br}} - 1.3281\)

Variables

Symbol Meaning SI unit
\(T\) Temperature K
\(T_b\) Normal boiling point K
\(T_c\) Critical temperature K
\(p_c\) Critical pressure Pa
\(F\) Miller factor -
\(\sigma\) Surface tension N/m

Method and standards

Brock–Bird–Miller corresponding states.

Where it is used

  • Foaming, wetting and packing calculations for organics.

Common mistakes

  • Using for water or alcohols.
  • Critical pressure in bar (the formula uses Pa; the calculator converts).

Assumptions and limits

  • Nonpolar and moderately polar organics.
  • Inconsistent critical constants can make the Miller factor zero or negative; the page then stops.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 2
  • Eqs. (2-118) and (2-119) (Brock and Bird, modified by Miller) with the ethyl mercaptan example

Questions and answers

What does Perry's example give?

Ethyl mercaptan at 303.15 K: 22.36 mN/m, 1.4 % below DIPPR.

When should I use the parachor instead?

When parachor groups and the liquid density are known; Brock–Bird needs only T_b, T_c and p_c.

Why the exponent 11/9?

It follows the near-critical scaling of surface tension with (1 − T_r).

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.