Worked example
Example: 40 % vol at 30 °C. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Strength entered as | % vol (by volume at 20 °C) |
| Alcoholic strength | 40.000 % |
| Temperature of the liquid | 30.000 °C |
Applying the formula below gives:
| Result | Value |
|---|---|
| Strength by mass | 33.300 % |
| Strength by volume at 20 °C | 40.000 % |
| Density at the temperature t | 941.19 kg/m³ |
| Density at 20 °C | 948.05 kg/m³ |
Open this example in the calculator and change any input.
Formula
\(\rho = A_1 + \sum_{k=2}^{12} A_k p^{k-1} + \sum_{k=1}^{6} B_k (t - 20)^k + \sum_{i=1}^{5}\sum_{k=1}^{m_i} C_{i,k}\, p^k (t - 20)^i\)
\(q = p\,\frac{\rho_{20}(p)}{\rho_{20}(1)}, \quad \rho_{20}(1) \approx 789.24\ \mathrm{kg/m^3}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{basis}\) | Strength entered as | - |
| \(s\) | Alcoholic strength | - |
| \(t\) | Temperature of the liquid | K |
| \(p\) | Strength by mass | - |
| \(q\) | Strength by volume at 20 °C | - |
| \(\rho_t\) | Density at the temperature t | kg/m³ |
| \(\rho_{20}\) | Density at 20 °C | kg/m³ |
| \(A_k, B_k, C_{i,k}\) | Coefficients of the R 22 formula (p. 13) | - |
Method and standards
The OIML R 22 (Wagenbreth–Blanke) polynomial with the published coefficients; strength by volume by the R 22 definition (introduction §4).
Where it is used
- Excise and customs gauging of spirits.
- Converting meter densities in distilleries and bottling halls.
Common mistakes
- Entering % vol where % mass is expected.
- Using the formula outside −20 to +40 °C.
Assumptions and limits
- Pure ethanol–water mixtures; other congeners shift the density slightly.
- Below 0 °C weak mixtures freeze. No freezing check is made: the formula returns a density for a mixture that would be frozen, and a note reminds you below 0 °C.
- Temperature on IPTS-68; the difference from ITS-90 is far below the table resolution.
References
- OIML R 22 (1973)
- Alcoholometry
- and International Alcoholometric Tables (1975): formula of Wagenbreth and Blanke
- pp. 12–13
Questions and answers
Why does the density depend on strength by mass?
R 22 writes its formula in strength by mass p; strength by volume is converted through q = p ρ20(p)/ρ20(1).
How exact is the formula?
It reproduces the printed tables to 0.01 kg/m³; the tables themselves are generated from it.
Can I use it above 40 °C?
No. The formula is fitted from −20 °C to +40 °C only.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.