FireCADCalc

Vacuum Cup Holding Force and Number of Cups

Holding force of a vacuum cup from vacuum and diameter, and the number of cups to lift a load horizontally or vertically with acceleration and safety factor.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 50 kg sheet, 80 mm cups, horizontalVertical panel 20 kg, 60 mm

g is added for the vertical component.

Results

Theoretical cup force; makers' rated forces are lower for porous or curved surfaces. On a vertical surface the cups hold by friction, so far more force is needed.

Theoretical force per cup197.92N
Required total force1,024.5N
Cups needed (rounded up)6.0000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 50 kg sheet, 80 mm cups, horizontal. The inputs, in the units selected above:

InputValue
Load mass50.000 kg
Vacuum (below atmospheric)60.000 kPa
Cup diameter80.000 mm
Acceleration of the handling motion5.0000 m/s²
Lift orientationHorizontal surface, vertical lift
Cup–load friction coefficient0.50000 -
Safety factor2.0000 -

Applying the formula below gives:

ResultValue
Theoretical force per cup301.59 N
Required total force1,480.7 N
Cups needed (rounded up)5.0000

Open this example in the calculator and change any input.

Formula

\(F_c = \Delta p\frac{\pi d^2}{4}, \quad F_{req} = m(g + a)S\ \text{(horizontal)}, \ \frac{m(g + a)S}{\mu}\ \text{(vertical)}\)

Variables

Symbol Meaning SI unit
\(m\) Load mass kg
\(\Delta p\) Vacuum (below atmospheric) Pa
\(d\) Cup diameter m
\(a\) Acceleration of the handling motion m/s²
\(\text{orientation}\) Lift orientation -
\(g\) Standard gravity, 9.80665 m/s²
\(\mu\) Cup–load friction coefficient -
\(S\) Safety factor -
\(F_c\) Theoretical force per cup N
\(F_{req}\) Required total force N
\(n\) Cups needed (rounded up) -

Method and standards

Statics.

Where it is used

  • Pick-and-place and sheet handling.
  • Vacuum lifters.

Common mistakes

  • Ignoring acceleration.
  • Using theoretical force for porous loads.

Assumptions and limits

  • Sealed cups; rigid load.

References

  • Pressure × area and friction statics (definitions)

Questions and answers

Why does orientation matter so much?

On a vertical surface the cups hold by friction alone: with μ = 0.5 you need twice the force.

What vacuum is practical?

60–80 kPa below atmosphere with ejectors; less for porous materials.

What do the defaults represent?

A 50 kg sheet lifted horizontally with 80 mm cups at 60 kPa vacuum.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.