FireCADCalc

Pneumatic Cylinder Air Consumption

Free air consumed by a double- or single-acting pneumatic cylinder per cycle and per minute from bore, rod, stroke, pressure and cycles, with the force.

Inputs

Examples: 63/20 mm, 200 mm stroke, 6 bar g, 10 per min, double acting32/12 mm, 100 mm, 6 bar g, 30 per min, single acting125/32 mm, 500 mm, 5 bar g, 4 per min, double

Results

Free air at atmospheric pressure; add the volume of hoses and valve passages, and leakage, in practice 10 to 20 % more.

Free air per cycle0.55666L
Free air consumption16.700L/min
Theoretical extend force0.48255kN

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 63/20 mm, 200 mm stroke, 6 bar g, 10 per min, double acting. The inputs, in the units selected above:

InputValue
Bore63.000 mm
Rod diameter20.000 mm
Stroke200.00 mm
Supply pressure (gauge)6.0000 bar
Cycles per minute10.000 -
CylinderDouble acting

Applying the formula below gives:

ResultValue
Free air per cycle8.1956 L
Free air consumption81.956 L/min
Theoretical extend force1.8703 kN

Open this example in the calculator and change any input.

Formula

\(V_c = \left[A s + (A - a) s\right]\frac{p + p_{atm}}{p_{atm}}, \quad Q = V_c\, n_c\)

Variables

Symbol Meaning SI unit
\(D\) Bore m
\(d\) Rod diameter m
\(s\) Stroke m
\(p\) Supply pressure (gauge) Pa
\(n_c\) Cycles per minute -
\(\text{acting}\) Cylinder -
\(V_c\) Free air per cycle m³
\(Q\) Free air consumption m³/s
\(F\) Theoretical extend force N

Method and standards

Swept volume at supply pressure converted to free air.

Where it is used

  • Compressor sizing.
  • Air audits.

Common mistakes

  • Gauge pressure as compression ratio.
  • Forgetting the return stroke.

Assumptions and limits

  • Full stroke each cycle.
  • Free air is at standard atmospheric pressure (101.325 kPa) and the supply-air temperature (isothermal filling); a FAD or ANR figure quoted at another reference temperature differs slightly.

References

  • Swept volume × compression ratio (p + p_atm)/p_atm

Questions and answers

63 mm bore, 20 mm rod, 200 mm stroke, 6 bar g, 10 cycles a minute?

About 8.2 L of free air per cycle, 82 L/min.

Why multiply by the compression ratio?

The cylinder fills with air at supply pressure, which is more free air.

What about hoses?

They are filled and exhausted every cycle too.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.