Worked example
Example: 10 m³/min for 1 min, 8 to 6 bar g. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Air drawn from the receiver (free air) | 10.000 m³/min |
| Time the receiver must supply it | 1.0000 min |
| Pressure at the start (cut-out) | 8.0000 bar g |
| Lowest acceptable pressure | 6.0000 bar g |
| Atmospheric pressure (absolute) | 101.33 kPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Receiver volume | 5.0663 m³ |
| Free air released | 10.000 m³ |
Open this example in the calculator and change any input.
Formula
\(V = \frac{\dot V_a\,t\,p_a}{p_1 - p_2} \qquad V_a = \dot V_a\,t\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V_a\) | free air drawn from the receiver | m³/s |
| \(t\) | time | s |
| \(p_1\) | start pressure | Pa |
| \(p_2\) | lowest pressure | Pa |
| \(p_a\) | atmospheric pressure | Pa |
| \(V\) | receiver volume | m³ |
| \(V_a\) | free air released | m³ |
Method and standards
Boyle's law at constant temperature between the two receiver pressures.
Where it is used
- Plant and instrument air receivers.
- Buffering compressor start-up.
- Peak demand from blow-off or soot blowers.
Common mistakes
- Using gauge pressures for p_a.
- Forgetting the dryer's own pressure drop.
- Undersizing for load–unload cycling.
Assumptions and limits
- Isothermal; leaks during the time not included. For a fast drawdown (close to adiabatic) the volume needed is up to about 1.4 times larger.
References
- Isothermal ideal-gas storage equation
Questions and answers
What receiver supplies 10 m³/min for a minute between 8 and 6 bar g?
5.07 m³ at 1.013 bar atmospheric: it releases 10 m³ of free air in that minute.
Why isothermal?
Air in a receiver stays near room temperature during slow draw-off. A fast draw-off is closer to adiabatic: the air cools as it expands, the pressure falls faster, and a larger receiver is needed (by up to the isentropic exponent, about 1.4 times).
Do I add the compressor output?
Enter only the demand the compressors cannot meet during the time.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.